21
Intended Use
This device is intended to chop foodstuffs which are suitable for
cutting.
It is only designed for this use and should only be used for this
intended purpose.
Only use this device as instructed in this user manual. Do not
use this device commercially.
No other use is intended and can cause damage or personal
injuries.
Clatronic International GmbH is not responsible for any
damages incurred due to improper use
Unpack Device
• Take the device out of its packaging.
• Remove all packaging materials, such as foils, lling
materials, cable ties and cartons.
• Check that all accessories are included in the box.
NOTE:
Clean manufacturing residues and dust from the device as
described under “Cleaning”.
Start-Up
1. Prepare the dish. Refer to the table below.
2. Place the rubber mat on a level, at surface. Place the
glass container on the rubber mat.
3. Use one knife or both knives depending on the quantity of
the food. Fit the knife (or the knives) carefully into the glass
bowl:
3.1. Fit the knife with the shaft onto the glass pin in the
center of the container.
3.2. If required, t the second knife with the blades facing
down onto the shaft of the rst knife.
4. Empty the desired foodstuffs into the container.
NOTE:
Do not overll the container; otherwise the foodstuffs
cannot be properly chopped (quantities see table)!
5. Place the safety cover onto the container in such way that
the blade shaft rests in the recess. The safety cover is
properly positioned if it cannot be moved.
NOTE:
Before use, always check that the silicone seal ts
correctly.
6. Place the motor unit on the cover. In doing so, use the
recesses in the safety cover.
7. Electric Connection
Connect the mains plug to a properly installed and earthed
220-240 V~, 50/60 Hz wall outlet.
NOTE:
• The motor unit is tted with a safety switch.
• If the device cannot be switched on, check that the
motor unit, safety cover and blade are tted correctly.
8. Hold the motor housing in your hand and press the LOW or
HIGH button at the same time.
LOW = low speed
HIGH = high speed.
The unit starts up.
CAUTION:
This device is suitable for short time operation (KB) of
maximum 20 seconds. Leave to cool down for at least
2 minutes before using the device again.
NOTE:
PULSE OPERATION: Briey press and release the
switch for pulse operation. Use the device in this mode for
maximum 1 minute. Leave to cool down for at least
2 minutes before using the device again!
9. After chopping, take your hand off the motor unit.
Disconnect from mains power supply.
10. Remove the motor unit from the transparent container.
11. Lift off the safety cover and carefully remove the blade.
12. Now you can empty the contents in the transparent
container.
Crushing ice: The blades in the mixing bowl are suitable for
breaking ice cubes. Fill the container no higher than the
0.75 marking with ice cubes. Only crush ice cubes in pulse
mode.
Table
Food Preparation
Max.
Quantity
Max. Duration
Boiled eggs
Shelled,
quartered
450 g
(1/4 pieces)
10 sec
Herbs 300 g 15 sec or pulse
Walnuts/
hazelnuts
Without
nutshells!
300 g 15 sec.
Almonds Without shells! 300 g 15 sec
Garlic Peeled 300 g 15 sec or pulse
Onions 2 cm cubes 300 g
5-10 sec or pulse
Parsley Wash, destalk 60 g 10 sec
Bread
(breadcrumbs)
2 cm cubes 80 g 15 sec or pulse
Meat
2 cm cubes,
without bones,
skin and
sinews!
300 g 15 sec or pulse
