10
Installation
• Read the manual thoroughly before operating the device!
• Choose a suitable location for the device. Suitable loca-
tions are dry, even and antislip surfaces on which you may
operate the device easily.
• Make sure there is proper ventilation for the device!
• Remove, if necessary, the protection sheet from the display.
• If necessary, screw the exible antenna onto the correct
connection.
Power supply (Adaptor)
• Insert the grid plug into a properly installed three prong
socket. Connect the device with the plug connector by
inserting its plug into the 7.5 V DC IN jack of the device.
• Make sure the grid voltage corresponds to the gures on
the rating plate.
CAUTION:
• Only use the supplied power adaptor for this device. Do
not use for other devices.
• Only use power adaptor with 7.5 V (
), other
adaptors may cause damage to the device.
NOTE:
• Disconnect from mains power supply during longer
periods of non-use.
• The preset time and stations will be lost as soon as you
disconnect the device from the mains.
Battery Operation (Batteries not included)
You can also operate the device with 4 batteries.
• Open the battery compartment (14) at the rear, loosen the
screw with a screw driver.
• Insert 4 batteries type UM 2/R14 1.5 V. Observe correct
polarity (see battery compartment)!
• Close the battery compartment and tighten the screw.
• To avoid battery leakage remove the batteries during longer
periods of non-use.
NOTE:
• Battery operation is automatically deactivated after con-
necting the power adaptor.
• If the display brightness (3) decreases, the batteries must
be replaced.
• The preset time and stations will be lost as soon as you
remove the batteries from the device.
WARNING:
Do not subject batteries to heat or direct sunlight. Do not
dispose of batteries by burning. Danger of explosion!
CAUTION:
• Different battery types or new and used batteries must
not be used together.
CAUTION:
• Do not dispose of batteries with the household waste.
Return exhausted batteries to collection points or your
dealer.
General operation
Turning the device on/ off
Press the POWER button (4), to turn the device on and off.
FUNCTION button (13)
For switching between FM, AM, USB and AUX mode.
VOL+/VOL- Volume (11)
Adjust to your preferred volume level.
Delayed shut-off (SLEEP)
The device automatically switches off when the selected time is
reached.
•
Select the time by repeatedly pressing the SNOOZE/SLEEP
button (12) after which the device switches off. Select from:
120, 90, 60, 45, 30 and 15 minutes. The SLEEP indicator
will appear in the display.
• Deactivating: If you press the SNOOZE/SLEEP button
once again after the 15 minutes are indicated, the SLEEP
indicator will disappear from the display. The function is
then deactivated.
NOTE:
Briey press the SNOOZE/SLEEP button to show the
remaining time.
Setting the time (in standby)
1. When in standby, press the
/MEM/TIME button (8). The
hours will start to ash.
2. You can make the adjustment with the PR-/ / PR+/ /
buttons (10).
3. Press the /MEM/TIME once more. The minutes will ash.
4. You can make the adjustment with the PR-/ / PR+/ but-
tons.
5. Save the time, by pressing the /MEM/TIME button once
again.
NOTE:
The preset time will be lost as soon as the power supply has
been interrupted.
Listening to the radio
Scan stations
1. Press the FUNCTION button (13) until “FM” or “AM” ap-
pears on the display, depending on which frequency band
you want to listen to.
FM = VHF, AM = Medium wave
