EnglishEnglish
Cleaning the dispenser units
This procedure should be carried out at the end of the working day on
all dispenser units.
Clean the underpan gasket with a brush.
Fit the blank ring into the filter holder (7), and pour in the con-
tent of a sachet or a measure of detergent powder.
Mount the filter holder (7).
Press one of the coffee dispensing knobs and, after a few sec-
onds, press the START/STOP (21) push button.
Repeat this procedure a few times.
Remove the filter holder (7), and clean the water “shower” with
a sponge.
Rinse for a few seconds with running water from each dis-
penser unit.
1.
2.
3.
4.
5.
6.
7.
Grids and drip pan
Remove the grids from the pan (26). Extract and clean them under
running water.
Discharge tank
At the end of the working day, pour a jug of hot water into the discharge
tank to remove any scaling.
Bodywork
Use a soft cloth and cleansing products WITHOUT ammonia or
abrasives.
1
3
2
Cleaning and maintenance
Cleaning the Filter Holders
All the filter holders should be cleaned at the end of the working day.
Pour 1 litre of cold water and a dose of detergent into a suitable
receptacle.
Remove the filters from the filter holders (7).
Leave the filters and filter holders (7) in the solution for at least
two hours.
Remove any residues with a sponge and rinse in plenty of cold
water.
Refit the filters in the filter holders (7), making sure that the filter
fixing spring is in the correct position.
1.
2.
3.
4.
5.
