767858

Chicco Next 2 Me Dream Handleiding

12
Verklein
Vergroot
Pagina terug
1/76
Pagina verder
12 13
you hear it click into place. Repeat the step on both sides.
6. Fasten the fabric lining ”E” to the central structure “C”
fastening the 2 straps with clip “C2” on the lower part of the
lining (g.7).
7. Fasten the buttons “C2” to the buttons “B5” to fasten the fabric
to the upper structure (g.8) and complete by closing the
zippers E3 (g.8A). Repeat the step for the missing side.
8. Position il mattress “F” on the bottom of the crib (g.9).
9. Block the 4 wheels “A6” of the crib by lowering the levers that
activate the brakes (g.10).
The crib is now ready to be used.
WARNING: Make sure that all the fasteners are engaged
correctly and that the zippers are closed and locked at the end.
WARNING: Do not use the crib with the articulated feet
partially or completely turned or released (g. 11). The position
of correct use is illustrated in gure 12. In the case of accidental
knocking against the articulated feet, put them back in the
correct position by lifting the crib slightly.
WARNING: If the crib has been used previously in “Co-Sleeping
conguration (fastened to the bed),” make sure that the side is
in locked position and check that it is engaged correctly.
ADJUSTING THE CRIB HEIGHT
The crib can be adjusted at dierent heights. To adjust the
height, the setting button “A1” up and lift the crib to the desired
position (g.13). Repeat the step on the opposite side.
The base of the crib can be slightly inclined by adjusting the 2
feet at dierent heights (g.14).
WARNING: The crib can be inclined by a maximum of 4
positions between one foot and the other (e.g., right foot in
position 5 and left foot in position 1, see g. 15).
WARNING: The child’s head must always be positioned near
the raised end (g.16).
WARNING: It is not possible to select dierent heights on the
two sides of the crib when in rocking conguration.
CO-SLEEPING CONFIGURATION (FASTENED TO THE BED)
It is possible to fasten the crib to the parents’ bed (co-sleeping
conguration).
CAUTION - IMPORTANT FOR YOUR CHILD’S SAFETY: This
conguration is allowed only with beds that allow complying
with all the conditions described in this paragraph.
In particular, the side of the crib must always be positioned
against the mattress of the parents’ bed and the parents’
mattress must be aligned with (or at most higher than) the
height of the crib’s side (g.17). Moreover, the crib must be
fastened to the frame of the parents’ bed or to the mattress
support (mesh or slat sprung base).
WARNING: Check that the structure of the crib in co-sleeping
conguration does not interfere with the parents’ bed.
WARNING: During use, make sure that the bedsheets, blankets,
etc. do not interfere with the crib’s space.
1. Lower the side of the crib “B2” by gripping the relevant
interface “B4” and rotating it upward to release the side
lowering mechanism (g.18).
WARNING: Use the crib with the bar lowered only in co-
sleeping conguration.
2. Put the crib against the parents’ bed and check the height of
the crib compared to the parents’ mattress.
WARNING: The height of the parents’ mattress must be higher
than or the same as that of the side of the crib. If this is not the
case, use the adjustment system to achieve this condition on
both sides.
WARNING: In co-sleeping conguration, the 2 feet of the crib
must be set at the same height.
3. To fasten the crib to the parents’ bed (co-sleeping
conguration), use the pair of supplied straps “D”. The straps
are found in the lower pocket “E2” of the fabric lining (g.19).
4. Fasten the grey buckles “C3” under the fabric lining on both
sides. Make sure the red buckle “D1” is positioned above the
strap as illustrated in gure 20.
5. Then run the strap around the structure of the parents’
bed from the bottom up (g.21) and fasten the red buckle
forming a noose (g.22). Repeat this operation on the other
side. To make installation easy, when fastening the buckles,
always keep the crib slightly away from the parents’ bed.
6. At this point put the crib against the parents’ bed and tighten
the noose pulling the straps (g.23). Carry out this step rst
on one side and then on the other, adjusting the straps until
the crib is in contact with the parents’ mattress.
WARNING: Before use, always make sure that there is no space
between the parents’ mattress and crib’s side. Otherwise adjust
the straps pulling them until the required condition is restored.
Make sure that the side is always free to be lowered and raised
completely.
7. Fit the length of the straps in excess inside the pocket on the
bottom of the fabric lining.
8. Lock the crib’s wheels.
If when fastening the crib to the parents’ bed it is not possible to
t the crib’s feet under the parents’ bed, the bed can be fastened
anyway by the following the instructions above and rotating the
articulated feet when putting the crib against the bed.
To turn the feet, pull the rotation release button “A4” and turn
the feet “A5” of the crib inward by hand (g.24).
9. To close the side that can be lowered, just pull up by holding
it by the upper mobile structure “B2” (g.25). Always make
sure that it is engaged correctly.
WARNING: Whenever the side is lowered, make sure that the
position compared to the parents’ mattress has not changed
from that illustrated in the paragraphs above.
WARNING: Never use the rocking function when the crib is in
“Co-Sleeping conguration (fastened to the bed).”
WARNING: Use the product with beds and/or mattresses with
straight sides only. Do not use the product with round beds
and/or mattresses or water mattresses.
WARNING: When the product is used in “Co-Sleeping
conguration (fastened to the bed),” it must always be mounted
on the long side of the bed. DO NOT install the product at the
head or feet of the bed.
CARE AND MAINTENANCE
The crib and mattress have a resistant fabric lining that can be
removed completely and washed.
To remove the fabric, follow the instructions in the paragraph
“HOW TO REMOVE THE FABRIC COVER.”
WARNING: Covering or removing the fabric may take a few
minutes and must be carried out by an adult.
Regularly inspect the toy for signs of wear and any damage.
In the case of damage do not use and keep out of reach of
children.
When washing the fabrics pay close attention to the
instructions on the label.
Do not use solvents, abrasive or overly aggressive products.
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
Check that the fabric and the stitching are in good condition
after each wash.
30° C
WARNING: When covering or removing the cover, take care
when handling the fabric parts so as to avoid accidental tears
or damage.
DOING THE BED
It is possible to unfasten the crib from the parents’ bed when
doing the bed. Just unfasten the grey buckles under the fabric
lining.
When fastening the crib again to the parents’ bed, pull the
straps again to make sure that the crib is correctly and securely
fastened to the parents’ bed. Make sure that all the steps
illustrated above in “Co-sleeping conguration (fastened to the
bed)” have been completed.
HOW TO REMOVE THE FABRIC COVER
1. Remove the mattress and unfasten the buttons in the lower
part of the fabric following the procedure illustrated in
“ASSEMBLY OF THE CRIB” in opposite order.
2. Open the 3 zippers “E3” on the upper structure “B” and
unfasten the 4 buttons fastening the fabric to the upper
structure.
3. Press the buttons on the fasteners of the feet, turn the upper
bar structure up and pull the upper structure out of the feet
(g.26A-B)
4. Then remove the fabric lining.
DISASSEMBLING THE CRIB:
The crib can be disassembled completely to put it away in
the supplied bag. In order to complete the disassembly of the
crib after removing the fabric, remove the lower bar and the
central support structure by repeating the steps illustrated in
“ASSEMBLY OF THE CRIB.”
ROCKING CONFIGURATION
To use rocking conguration:
1. Pull out the slides “A2” on the lower part of the feet of the
crib positioning the foot near the centre of the top of each
slide and, holding the upper edge of the crib with your hand,
pull the crib up while holding the crib down with your foot
(g.27).
2. Repeat the same operation for both sides.
3. To deactivate rocking conguration, just press the button “A7”
at the centre of the slide on each side and then accompany
the crib down holding by the upper edge so that the slide
returns to closed position (g.28). Always make sure that the
slide has returned to closed position.
WARNING: Always remember to deactivate rocking
conguration when using the product in “co-sleeping (fastened
to the bed)” or when the child is unattended.
WARNING: It is not possible to select dierent heights on the
two sides of the crib when in rocking conguration.
WARRANTY
The product is guaranteed against any conformity defect in
normal conditions of use as provided for by the instructions
for use. The warranty shall not therefore apply in the case of
damages caused by improper use, wear or accidental events.
For the duration of warranty on conformity defects please refer
to the specic provisions of national laws applicable in the
country of purchase, where provided.
… 12 …

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Chicco Next 2 Me Dream bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Chicco Next 2 Me Dream in de taal/talen: Alle talen als bijlage per email.

De handleiding is 3,87 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info