Operation of appliances
WC
?
The toilet has two parts: a permanently-fixed part and
a waste-holding tank accessible from the outside. The
removable waste-holding tank is located underneath the
bowl and can be removed via a hatch on the outside of
the camper.
Start up
1. Open the access hatch on the outside of your camper.
2. Remove the waste-holding tank by pulling the safety
catch (which holds the tank in place) upwards.
3. Pull the waste-holding tank outwards until the end
stop. Tilt it slightly and remove it completely.
4. Place the waste-holding tank upright and turn the
rotating emptying spout upwards. The emptying spout
is used to empty the tank easily and hygienically.
5. Remove the cap (with the measuring cup inside) from
the emptying spout and pour the correct dosage of
Thetford toilet fluid (see product label) into the waste-
holding tank. This avoids unpleasant smells and keeps
the inside of the tank clean.
Next add approximately two litres of water - enough to
cover the bottom of the tank completely.
=+,,"/$0 never add toilet fluid directly via the blade
or bowl as this could damage the lip seal on the waste-
holding tank.
Always pour the fluids via the emptying spout.
6. Slide the waste-holding tank back into its original
position via the access hatch. Make sure that it is
secured with the safety catch. Close and lock the
access hatch.
Using the toilet (standard)
Turn the bowl to the desired position with the cover
closed and using both hands.
To activate the control panel, press the flush-button
once. The control panel display will stay activated for
approximately 5 minutes. Run some water into the bowl
by pressing the flush button again briefly.
You can use the toilet with the blade open or closed.
Watch out for the air pressure when opening the WC cassette trap, especially when travelling in the mountains. Open
it then with the WC bowl lid closed. You will find below a short description on using this equipment.
Specific documentation is supplied with the camper.
!
CHEMICAL WC MODEL 0250
54
