Handleiding Charnwood Bembridge (pagina 7 van 20) (Engels)

694419

Verklein

Vergroot

Pagina terug

1/20

Pagina verder

‘click position’ or for low burning to the fully closed position.

When the fire is burning normally the air control gives enough

airwash to keep the glass clean. However, it will not always be

possible to keep the glass clean with the air control fully closed.

Keep the firebox well filled but do not allow fuel to spill over the top

of the fuel retainer.

Logs should be evenly distributed, filling the firebed to give the most

pleasing flame pattern. The air control must be fully opened after

refuelling until the flames are established above the fire. It is best to

refuel on to a hot bed of embers. If at this point the fire starts to die,

the door must be cracked open until the fire is revived. If the fire has

started to die down before refuelling, then more kindling wood must

be added, the air control opened fully and the door cracked open to

re-establish the firebed before adding larger logs (see suitable log

sizes in Fuel section). This will avoid excessive smoke emission.

Care should be taken, especially when burning wood, that fuel does

not project over the fuel retainer or damage to the glass may be

caused when the door is closed. It can also cause the glass to blacken

up. Maximum filling height is such that logs cannot fall from the fire

when the door is opened.

For

correct firing we recommend the use of a stove pipe thermometer

which may be purchased from your supplier or from Charnwood.

Maximum filling height is such that logs cannot fall from the fire when

the door is opened. In smoke controlled areas do not fill then stove

above the level of the air holes in the back bricks, as overloading can

cause excess smoke.

Do not operate with the door left open except as directed by the

instructions as this can cause excessive smoke.

For optimum wood burning, it is important to leave a layer of ash

around 1cm thick on the base of the stove. Before removing ash

ensure that it has cooled down, scoop out the remaining ash and

empty into a metal container. Please avoid emptying hot ash into

plastic liners or bins.

To make ash removal easier there are scoops and ash carriers

available. These may be purchased from your supplier or, in case of

difficulty, from Charnwood.

If an Optional Wood Ash Removal Grate is fitted, the Ashpan should

REFUELLING

ASH CLEARANCE

be emptied regularly before it becomes too full. Never allow the ash

to accumulate in the ashpan so that it comes in contact with the

underside of the grate as this will seriously damage the grate bars.

The ashpan is handled using the Door Opening tool and gloves

provided. Ensure that the tool is fully engaged before lifting (See

Fig.4). When carrying the ashpan, it should be kept horizontal and

supported by the carrying handle to prevent it falling off the tool.

REDUCED BURNING

MAINTENANCE

For reduced burning the fire door must be closed.

When burning wood in areas that are not smoke controlled, load

some large logs on the fire and allow to burn for half an hour before

closing the air control (this will help to reduce tar deposits in the

chimney). Some experimentation may be necessary to find the setting

most suitable for the type of fuel being used and the draw on the

chimney.

Cleaning

Cleaning the Glass

The stove is finished with a high temperature paint which will

withstand the temperatures encountered in normal use. This may be

cleaned with a damp lint-free cloth when the stove is cold. Should re-

painting become necessary, high temperature paints are available

from your supplier or from stove shops.

Most deposits on the glass may be burnt off simply by running the fire

at a fast rate for a few minutes. If it becomes necessary to clean the

glass then open the door and allow it to cool. Clean the glass using a

damp cloth and then wiping over with a dry cloth. Any stubborn

deposits on the glass may be removed with a proprietary stove glass

cleaner or ceramic hob cleaner. Do not use abrasive cleaners or pads

as these can scratch the surface which will weaken the glass and cause

premature failure

OPERATING INSTRUCTIONS

Fig.4.Ash Removal

Ashpan

Ashpan Tool

Extra carrying handle. Use with glove

Ashpan Tool

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Charnwood Bembridge Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van Charnwood Bembridge

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info