USER GUIDE
For 34956
EN
Introduction
Wireless outdoor strobe siren is to deter the intruders through
hooting once it receives wireless signal from connected control
panel or sensors. More wireless strobe sirens could be connected
to the same control panel to strengthen the deterring effect. When
the siren is connected to control panel as an accessory, it will hoot
siren is connected to accessories like remote control, door/window
contact, and PIR motion detector, etc. as a standalone alarm
triggered.
Product Overview
Front View
Alarm LED
Indicators
Status LED Indicator
Status LED Indication
Status LED
Arm/Home Mode Flash once every 5 seconds
Disarm No light indication
No disarm operation
after alarm
Flash once every 2 seconds for 2 hours
Rear View
Mounting Holes
Back Cover
Tamper Switch
Bracket
PCB Layout
Siren Interface
Learn Button
Adapter Jack
DC 12V
Terminals
Wired Sensor Terminals (Normal Zone)
Wired Sensor Terminals (24-H Zone)
Battery Slot
Alarming Volume Setup
Alarming Duration Setup
Jumper Setup
Please setup alarming volume and alarming duration time on the
PCB board accordingly.
Alarming Volume Setup
HIGH MUTE LOW
HIGH
HIGH
HIGH
MUTE
MUTE
MUTE
L
OW
L
OW
L
OW
Default Setting
Note: When the siren is connected to control panel, it will hoot at the pre-
set volume even if the control panel is set to mute alarm. This is to alert the
neighbors and avoid the intrusion. When the control panel is set to mute
disarm/arm, the siren will be disarmed/ armed mutely. When the siren is set
to mute mode, there are still tones for arming and disarming.
Alarming Duration Setup
5 MIN
5MIN
5 MIN
2 MIN
2 MIN
2 MIN
30S
30S
30S
5 MIN 2 MIN 30S
Default Setting
Work as Wireless Siren
When it works as a wireless siren, it should be connected with
wireless control panel in advance. When the control panel is
intruders.
Connect to Control Panel
Press the Learn Button for
0.5 second, siren beeps once
and enter connection status.
Press [SOS] or [Arm ] button
on the panel (or press Arm on
App if the panel does not have
a button), the wireless siren and
control panel are connected
successfully after one beep is
heard from siren.
Note: Once the siren is in connection status, please press Learn Button again
to exit. One beep will be heard from siren.
When connecting to control panel, please don't trigger any other sensors to
avoid interference.
Disconnection
Hold the learn button till 2 beeps are heard to disconnect the siren
and control panel.
www.chacon.be