USER GUIDE
For 34957
www.chacon.be
EN
Features
1. Compact size with plug-in design
2.
3. Built-in 1,000,000 RF codes combination maintains high reliability
4. E
2
PROM information protection, power failure won't cause damage
to data
5. Easy to pair automatically with accessories
6. Work with all kinds of our wireless accessories
7. Mute operation for night, not disturbing neighborhood
8. Built-in 3.7V 600mAh lithium battery enables 8-hour standby
Introduction
The wireless siren is powered by AC 100V ~ 240V, without need of
wiring. According to different requirements, users can install more
wireless sirens indoor in different places to deter the illegal intruders.
Multiple wireless sirens in different places can be wirelessly
connected with the control panel to build a system. When the
control panel receives alarm signals from detectors, wireless sirens
The wireless siren can also be used as a control panel independently.
According to different requirements, users can build up a standalone
on-site alarm system by connecting new homo-frequency
accessories with this siren.
Product Overview
①
Power Switch/Connect Button
②
Strobe Light
③
Siren
Power On/Off
Power On
The siren is powered off in default setting. Plug the siren into AC
power socket, and then press the power switch button. The siren is
powered on after a long beep.
Power Off
Press connect button once under working status. Then press the
connect button for 6 seconds until a long beep is heard. The siren is
powered off.
Strobe Light Indication
Work as Wireless Siren
When it works as a wireless siren, the siren should be connected
with wireless control panel in advance. When the control panel is
intruders.
Connect to Control Panel
Firstly, press the connect button (0.5 seconds), the wireless siren
beeps once. 3 seconds later, it gives out another beep and the
Secondly, press [SOS] or [Arm] button on the panel, the wireless
siren and control panel are connected successfully after one beep.
Press connect button again to exit connecting status after one beep.
Notes: Please don't trigger any accessory when connecting with the control
panel.
Testing:
Press the [Arm] button on the remote control, if the built-in siren
of control panel and wireless siren beep once, the connection is
successful. If not, the connection fails, please reconnect them.
Work as Standalone Alarm
The siren can build up a standalone alarm system by adding
wireless accessories.
When the siren is armed, if any sensor is triggered, the siren will
Connect Wireless Accessories
Firstly, press the connect button (0.5 seconds), the wireless siren
beeps once. 3 seconds later, it gives out another beep and the
Secondly, trigger the wireless accessory once (such as press any
button on the remote control / separate the transmitter and magnet
of the door contact / press the test button of motion detector), and
it will be connected after one beep. Repeat the above operation to
connect other accessories.
Note: The siren supports up to 40 wireless accessories.
Testing:
Press the [Arm] button on the remote control, if the wireless
is successful. Then trigger the sensor, siren will hoot. If not, the
connection fails, please reconnect.
Delete All Accessories or Panels
If you lose the wireless accessories especially the wireless remote
controls, it is recommended to delete all the accessories and then
re-connect for safety.
Press down the connect button for 6 seconds until one beep is
connected accessories and panels are deleted.