624521
5
Verklein
Vergroot
Pagina terug
1/6
Pagina verder
Operation Guide 3180
5
Recovery Times
The table below shows the amount exposure that is required to take the
battery from one level to the next.
The above exposure time values are all for reference only. Actual required
exposure times depend on lighting conditions.
Approximate Exposure Time
Level 5 Level 4 Level 3 Level 2 Level 1
3 hours 18 hours 5 hours
9 hours 90 hours 24 hours
14 hours 182 hours 49 hours
155 hours - - - - - - - - - - - - - - - -
Exposure Level
(Brightness)
Outdoor Sunlight
(50,000 lux)
Sunlight Through a
Window (10,000 lux)
Daylight Through a
Window on a Cloudy
Day (5,000 lux)
Indoor Fluorescent
Lighting (500 lux)
Reference
This section contains more detailed and technical information about watch
operation. It also contains important precautions and notes about the various
features and functions of this watch.
Graphic Area
The information shown in the graphic area depends on the current mode.
Mode
Timekeeping
World Time
Alarm
Stopwatch
CountdownTimer
Graphic Area
Timekeeping Mode seconds
Timekeeping Mode seconds
Rotates when the time is reached
Stopwatch Mode 1/10 seconds
CountdownTimer Mode seconds
Rotates when the time is reached
Graphic Area
Button Operation Tone
The button operation tone sounds any time you
press one of the watchs buttons. You can turn the
button operation tone on and off as desired.
Even if you turn off the button operation tone,
the alarms, the Hourly Time Signal, and the
countdown alarm all operate normally.
To turn the button operation tone on and off
1. In the Timekeeping Mode, hold down A until the display contents start to
flash. This is the setting screen.
2. Press C nine times to display the current button operation tone setting
(
or ).
3. Press D to toggle the button operation tone on (
) or off ( ).
4. Press A to exit the setting screen.
The
indicator is displayed in all modes when the button operation tone
is turned off.
MUTE indicator
Power Saving Function
When turned on, the Power Saving function
enters a sleep state automatically whenever the
watch is left in an area for a certain period where
it is dark. The table below shows how watch
functions are affected by the Power Saving
function.
Elapsed Time
in Dark
60 to 70 minutes
6 or 7 days
Display
Blank, with Power Saving on
indicator ( ) flashing
Blank, with Power Saving on
indicator (
) displayed (not
flashing)
Operation
All functions enabled, except
for the display
Beeper tone, illumination,
and display are disabled.
Wearing the watch inside the sleeve of clothing can cause it to enter the
sleep state.
The watch will not enter the sleep state between 6:00 AM and 9:59 PM. If
the watch is already in the sleep state when 6:00 AM arrives, however, it
will remain in the sleep state.
Power saving on indicator
To recover from the sleep state
Perform any one of the following operations.
Move the watch to a well-lit area.
Press any button.
Angle the watch toward your face for reading.
To turn Power Saving on and off
1. In the Timekeeping Mode, hold down A until
the city code starts to flash, which indicates
the setting screen.
2. Press C eleven times until the Power Saving
on/off screen appears.
3. Press D to toggle Power Saving on (
) and
off (
).
4. Press A to exit the setting screen.
The Power Saving on indicator (
) is displayed
in all modes while Power Saving is turned on.
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
On/Off status
Auto Return
If you do not perform any operation for about two or three minutes while a
setting screen (with a flashing setting) is on the display, the watch will exit the
setting screen automatically.
Scrolling
The B and D buttons are used in various modes and setting screens to
scroll through data on the display. In most cases, holding down these buttons
during a scroll operation scrolls at high speed.
Initial Screens
When you enter the World Time Mode, or Alarm Mode, the data you were
viewing when you last exited the mode appears first.
Timekeeping
Resetting the seconds to 00 while the current count is in the range of 30 to
59 causes the minutes to be increased by 1. In the range of 00 to 29, the
seconds are reset to 00 without changing the minutes.
The year can be set in the range of 2000 to 2099.
The watchs built-in full automatic calendar makes allowances for different
month lengths and leap years. Once you set the date, there should be no
reason to change it except after you have the watchs battery replaced or
the battery drops to Level 5.
The current time for all city codes in the Timekeeping Mode and World Time
Mode is calculated in accordance with the Coordinated Universal Time
(UTC) for each city, based on your Home City time setting.
World Time
The seconds count of the World Time is synchronized with the seconds count
of the Timekeeping Mode.
Illumination Precautions
The electro-luminescent panel that provides illumination loses power after
very long use.
Illumination may be difficult to see when viewed under direct sunlight.
The watch may emit an audible sound whenever the display is illuminated.
This is due to vibration of the EL panel used for illumination, and does not
indicate malfunction.
Illumination turns off automatically whenever an alarm sounds.
Frequent use of illumination runs down the battery.
Auto light switch precautions
Avoid wearing the watch on the inside of your wrist. Doing so causes the
auto light switch to operate when it is not needed, which shortens battery
life. If you want to wear the watch on the inside of your wrist, turn off the
auto light switch feature.
Illumination turns off after a preset amount of time (1.5 or 3 seconds), even
if you keep the watch pointed toward your face.
Static electricity or magnetic force can interfere with proper operation of the
auto light switch. If illumination does not turn on, try moving the watch back
to the starting position (parallel with the ground) and then tilt it back toward
you again. If this does not work, drop your arm all the way down so it hangs
at your side, and then bring it back up again.
Under certain conditions, illumination may not turn on until about one
second after you turn the face of the watch toward you. This does not
necessarily indicate malfunction of the auto light switch.
You may notice a very faint clicking sound coming from the watch when it is
shaken back and forth. This sound is caused by mechanical operation of
the auto light switch, and does not indicate a problem with the watch.
Specifications
Accuracy at normal temperature: ± 15 seconds a month
Timekeeping: Hour, minutes, seconds, p.m. (P), month, day, day of the week
Time format: 12-hour and 24-hour
Calendar system: Full Auto-calendar pre-programmed from the year 2000 to
2099
Other: Home City code (can be assigned one of 48 city codes); Standard
Time / Daylight Saving Time (summer time)
World Time: 48 cities (31 time zones)
Other: Daylight Saving Time/Standard Time
Alarms: 5 daily alarms (four daily alarms; one snooze alarm); Hourly Time
Signal
Stopwatch:
Measuring unit: 1/100 second
Measuring capacity: 23:59' 59.99''
Measuring modes: Elapsed time, split time, two finishes
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Casio 3180 - DW-5600 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Casio 3180 - DW-5600 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,87 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Casio 3180 - DW-5600

Casio 3180 - DW-5600 Gebruiksaanwijzing - Deutsch - 5 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info