134526
7
Verklein
Vergroot
Pagina terug
1/101
Pagina verder
EN
When the installation plate is directly mounted on the wall
1.Securely fit the installation plate onto the wall by screwing it in the
upper and lower parts to hook up the indoor unit.
2.To mount the installation plate on a concrete wall with anchor
bolts, use the anchor bolt holes as illustrated in the below figure.
3.Install the installation plate horizontally in the wall.
CAUTION
Failure to firmly install the unit may result in personal injury and
property damage if the unit falls.
In case of block, brick, concrete or similar type walls, make 5 mm
dia. holes in the wall.
Insert clip anchors for appropriate mounting screws 7.
CAUTION
When installing the installation plate with a mounting screw,
do not use the anchor bolt holes. Otherwise, the unit may fall
down and result in personal injury and property damage.
NOTE
Secure four corners and lower parts of the installation plate with
4 to 6 mounting screws to install it.
5 m
5
m
45°
4
5
°
7
5
°
* 7 m
7 m
INDOOR UNIT
Installation Place
A place which provides the spaces around the indoor unit as
shown in the diagram
A place where there are no obstacles near the air inlet and outlet
A place which allows easy installation of the piping to the outdoor
unit
A place which allows the front panel to be opened
The indoor unit shall be installed as top of the indoor unit comes
to at least 2 m height.
Also, it must be avoided to put anything on
the top of the indoor unit.
CAUTION
Direct sunlight to the indoor unit’s wireless receiver should be
avoided.
The microprocessor in the indoor unit should not be too close
to RF noise sources.
(For details, see the owner’s manual.)
(Top view)
* : Axial distance
Reception
range
Reception range
Remote
control
Indoor unit
Remote control
(Side view)
Remote control
A place where there are no obstacles such as a curtain that may
block the signal from the indoor unit
Do not install the remote control in a place exposed to direct
sunlight or close to a heating source such as a stove.
Keep the remote control at least 1 m apart from the nearest TV
set or stereo equipment. (This is necessary to prevent image
disturbances or noise interference.)
The location of the remote control should be determined as
shown below.
Cutting a hole
When installing the refrigerant pipes from the rear
The center of the pipe hole
is above the arrow.
Cutting a Hole and Mounting
Installation Plate
NOTE
When drilling a wall that contains a metal lath, wire lath or metal
plate, be sure to use a pipe hole brim ring sold separately.
1.After determining the pipe hole position on the mounting plate
(A), drill the pipe hole (65 mm) at a slight downward slant to
the outdoor side.
65 mm
100 mm
Pipe hole
Indoor unit
62
85
82.5
170
Anchor bolt holes
Hook
Pipe hole
Indoor unit
Thread
Hook
Weight
Pipe hole
7 Mounting screw
Hook
1
Installation
plate
2 m or more from floor
Mounting the installation plate
3
Installation plate
(Keep horizontal direction.)
Projection
15 mm or less
Anchor bolt
Clip anchor
(local parts)
Clip anchor
(local parts)
5 mm dia. hole
7 Mounting screw
4 x 25
ss
ss
s
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Carrier 42hqv035 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Carrier 42hqv035 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans, Pools, Zweeds, Noors, Fins als bijlage per email.

De handleiding is 3,38 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info