41
Setting
Lamp mode
This function allows you to change the brightness of the screen.
Normal.........normal brightness
Auto.............brightness according with the input signal
Silent ..........lower brightness reduces the lamp power
consumption and extends the lamp life.
The sound is quiet.
On start
When this function is “On”, the projector is automatically turned
on just by connecting the AC power cord to a wall outlet.
Press the Point
7 8 button to switch On / Off.
✔Note:
• Be sure to turn the projector off properly (see “Turning Off the Projector” on page
18). If the projector is turned off in the incorrect sequence, such as disconnecting
the AC power cord before completing the cool down etc., the On start function does
not operate properly.
Power management
Time left until Lamp off
Press the OK button at Power
management and this box
appears. Select one of three
settings with the Point 7 8
buttons, and go to the timer
with the Point
eedd
buttons
and set time with the Point 7
8 buttons.
Power management
For reducing power consumption as well as maintaining the lamp
life, the Power management function turns off the projection lamp
when the input signal is interrupted and no button is pressed for a
certain period.
If the input signal is interrupted and no button is pressed for 30
seconds or more, the timer display with the message "No signal"
appears on the screen. The count-down of the set time will get
started. The count-down time can be set between 1 and 30
minutes. Set the count-down time with
Point 7 8 buttons.
When the count-down time has been elapsed, the lamp will be
turned off to cool itself down. The POWER indicator is blinking red
during this cooling-off period. The next operation depends on the
setting as follows :
Ready . . . . . .When the lamp has been fully cooled down, the
POWER indicator changes to green blinking. In
this condition, the projection lamp will be turned
on if the input signal is reconnected or any
button on the top control or remote control unit
is pressed.
Shutdown . . .When the lamp has been fully cooled down, the
power will be turned off.
Off . . . . . . . . .The Power management function is canceled.
Setting
