8. AUTOMATIC
WASHING/DRYING
CYCLE
- Washing
! Open the drawer and put in the correct
amount of detergent.
! Refer to the list of washing programmes
for the fabrics to be washed (e.g. very
dirty cotton) and turn the selector knob to
the required programme.
! Adjust the wash temperature if
necessary.
! Press the option buttons (if required).
! Check that the tap is turned on and that
the discharge hose is positioned
correctly.
- Drying
! Select the degree of dryness that you
require choosing one of 3 automatic
programmes:
! If you wish to select a timed drying
programme, press the "DRYING
SELECTION" button until the required
time indicator lights up.
! Press the START/PAUSE button.
! The programme selector remains in the
same stationery position throughout the
cycle until it ends.
! At the end of the wash phase the display
will show the drying time remaining.
! The washer dryer will then complete the
entire drying programme.
! The drying programme indicator will be
on, until the cool down phase begins and
the corresponding indicator is on.
! When the programme is finished the word
"End" will appear on the display. After 5
minutes the appliance will go into
standby mode (on certain models, the
display will show two lines).
! After the programme has finished please
wait for about 2 minutes until the DOOR
LOCKED indicator has gone out before
opening the door.
! Switch off the machine by turning the
programme selector to the OFF position.
! Open the door and remove the laundry.
! Turn off the tap.
CANCELLING THE DRYING PROGRAMME
! To cancel the drying programme, press
and hold the DRYING SELECTION
button for about 3 seconds.
You cannot exceed the maximum
dryable load of laundry indicated in
the programme table, otherwise the
laundry will not be dried satisfactory.
