DRYING
DON’T DRY GARMENTS MADE FROM FOAM RUBBER
OR FLAMMABLE MATERIALS.
IMPORTANT:
THIS DRYER CAN ONLY BE USED FOR LAUNDRY
WHICH HAS BEEN WASHED AND SPIN DRIED.
WARNING:
Indications given are general, therefore some practice is needed for the best drying results.
We recommend setting a lower drying time than indicated, when first using, so as to
establish the degree of dryness required. We recommend not to dry fabrics that fray easily,
such as rugs or garments with a deep pile, to avoid air duct clogging.
The water is then conveyed to the drain circuit, wich is sealed and therefore, no steam can
be released outside.
Important
Never open the door after the drying cycle has begun -
wait until the cool down period provided for by the
cycle.
Only dry pre-spun laundry
The washer/dryer can perform two types of drying:
1 Cotton, terry towelling, linen, hemp fabrics, etc... symbol on programme dial (P).
2 Mixed fabrics (synthetics/cotton), synthetic fabrics symbol on programme dial (P).
24
25
Automatic washing/drying
Warning: only a maximum 4 kg of dry laundry can be loaded.
Refer to the list of washing programmes according to fabrics to be washed (e.g. very dirty
cotton) and without pressing Start button, prepare wash as described:
Selecting the wash programme
Refer to the programme guide or the programme descriptions on the machine to select the
most suitable programme.
Turning the selector knob, the required programme is activated.
Wait for the “STOP” indicator light to flash.
Press additional function buttons (if required).
Check that the tap is turned on and that the discharge hose is positioned correctly.
DRYING:
Refer to the drying programme table and depending on the fabrics to be dried (e.g. cotton),
programme the drying as follows:
- If you would like your fabrics cupboard dry, turn the “drying programme selector” knob until
the position.
- If you would like your fabrics iron dry, turn the “drying programme selector” knob, until
the position.
- If you wish to select a timed drying cycle, turn the “drying programme selector” knob until
the Timed position 120 or 60 or 30.
Press the "Start/Pause" button.
When the "Start/Pause" button is pressed the machine sets the working sequence in
motion.
The programme carries out with the programme selector stationary on the selected
programme till cycle ends.
The washer-dryer will then complete the entire drying programme.
When the programme is finished
At the end of the programme the indicator light “STOP” will go on.
Wait for the door lock to be released (about 2 minutes after the programme has finished).
The "Door Security" indicator light will go out. Turn the “drying programme selector” knob on
the position.
Switch off the machine by turning the programme selector on the “OFF” position. Open the
door and remove the laundry. Turn off the tap.
