Note: we recommend you keep the screws to
immobilise the machine for future transit.
The Manufacturers will not be responsible for any
possible damage to the machine caused by not
following the rules relating to releasing the mechanism.
The user is responsible for all costs of installation.
Water connection
The appliance must be connected to the water mains using new
hose-sets.
The old hose-sets should not be re-used.
The machine has an inlet hose with 3/4" B.S.P threaded end
connection to attach between the threaded connector on the
appliance and the cold water supply.
This machine only uses cold water, therefore
only one hose is needed to connect to the cold
water supply. Do not connect to the hot supply.
Cold fill is an energy efficient system. Only the
water required for the washing is heated.There
is no loss of heat in the pipeline from a hot
water tank or boiler to the machine.
29
28
SETTING UP + INSTALLATION
Remove the polystyrene base and place the machine near
its permanent position (diagram 1).
Carefully cut through the hose retaining clip at the rear of
the appliance (diagram 2).
Unscrews the two top screws A and remove the cover,
sliding it off horizontally (diagram 3).
Remove the cardboard protection.
Unscrews the two tie braces B on the crosspiece (with an H.
19 spanner) and remove the polystyrene spacers under it
(diagram 4).
Please do not fit the 2 tie braces B again!
IMPORTANT: DO NOT REMOVE THE SPACERS ABOVE THE CROSSPIECE.
Replace the cover with the two screws A.
Please ensure when fitting the table top the locating pins are inserted correctly in their slots,
positioned on the side of the cabinet as shown in the diagram 5.
WARNING:
DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A
POTENTIAL SOURCE OF DANGER.
Apply the insulation sheet of
corrugated material to the base as
shown in the relevant diagram.
Level the machine by means of the
front feet.
a) Turn the nut clockwise to release
the screw adjuster on the foot.
b) Rotate the foot to raise or lower it until it stands firmly on the
ground.
c) Lock the foot in position by turning the nut anti-clockwise until it
comes up against the bottom of the machine.
