Important safety instructions
Please take a moment to read these instructions before installing your iD10, as they will enable you to get the best performance and prolong the
life of the unit. We advise you follow all instructions, heed all warnings and keep the instructions for future reference.
Positioning
Choose the installation location carefully. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibration
and excessive dust, cold or moisture. Do not place the unit on an unstable surface or shelf. The unit may fall, causing serious injury to a child or
adult as well as serious damage to the product. Do not place other equipment on top of the unit. Do not install near any heat sources such as
radiators, heat registers, stoves, or other unit (including amplifiers) that produce heat. No naked flame sources, such as lighted candles, should
be placed on the unit.
Use only with cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the unit. When a cart is used, use caution
when moving the cart/unit combination to avoid injury from tip-over. This unit must be installed on a sturdy, level surface. Do not place in
a sealed area such as a bookcase or in a cabinet.
WARNING - To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. This unit must not be used near water or exposed
to dripping or splashing water or other liquids. No objects filled with liquid, such as vases, shall be placed on the unit. In the event, switch off
immediately, disconnect from the mains supply and contact your dealer for advice. The unit can be used in moderate climate.
Electronic audio components have a running in period of around a week (if used several hours per day). This will allow the new components to
settle down, the sonic properties will improve over this time.
Grounding and polarisation
Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades with one wider than the other. A
grounding type plug has two blades and a third grounding prong. The wide blade or third prong are provided for your safety. If the provided plug
does not fit your outlet, consult an electrician for replacement of the obsolete outlet.
Power sources
The unit should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power-supply to
your home, consult your product dealer or local Power Company.
Power cord protection
The unit must be installed in a manner that makes disconnection of the power supply from the mains socket outlet (or appliance connector from
the rear of the unit) possible. Where the power supply is used as the disconnect device, the disconnect device shall remain readily operable.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the unit.
Be sure to insert each power cord securely. To prevent hum and noise, do not bundle interconnect leads with the power cord or speaker leads.
Overloading
Do not overload wall outlets or extension cord as this can result in a risk of fire or electric shock. Overloaded AC outlets, extension cords, frayed
power cords, damaged or cracked wire insulation, and broken plugs are dangerous. They may result in a shock or fire hazard.
Lightning
For added protection during a thunderstorm, or when it is left unattended and unused for long period of time, unplug the unit from the wall outlet
and disconnect the antenna or cable system. This will prevent damage to the unit from lightning and power-line surges.
Cleaning
To clean the unit, wipe its case with a dry, lint-free cloth. Do not use any cleaning fluids containing alcohol, ammonia or abrasives. Do not spray an
aerosol at or near the unit. The use of a lens cleaning disc at least once a month can also prolong unit life.
Attachments
Do not use attachments not recommended by your dealer as they may cause harm to the unit. Only use the specified attachments/accessories
with this unit.
Servicing
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply
cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped. These units are not user serviceable, never attempt to repair, disassemble or reconstruct the unit
if there seems to be a problem. A serious electric shock could result if this precautionary measure is ignored. In the event of a problem or failure,
please contact your dealer.
Contact the service department should any of these conditions occur:
- When the power-supply cord or plug is damaged.
- If liquid has been spilled, or objects have fallen into the unit.
- If the unit has been exposed to rain or water.
- If the unit does not operate normally after following the operation instructions, adjust only those controls that are covered by the operation
instructions.
- If the unit has been dropped or damaged in any way.
- When the unit exhibits a distinct negative change in performance.
