ENGLISH
11
ENGLISH
10
Cause
The car ignition switch is not on
The fuse is blown
Presence of disc inside the player
Inserting the disc in reverse direction
The disc is extremely dirty or defective
Temperature inside the car is too high
Condensation
Volume is in minimum
Wiring is not properly connected
The installation angle is more than 30 degrees
The disc is extremely dirty or defective
The built-in microcomputer
is not operating properly due to noise
The antenna cable is not connected
The signals are too weak
Mechanism error
The media device is not able to copy or record
The media device is not able to play file
The media device memory is full, is not allow to copy
No file format supports for playback on the disc/media device
Maybe disc dirty/disc scratched/disc upside down
Solution
If the power supply is properly connected to the car
accessory terminal,switch the ignition key to "ACC"
Replace the fuse
Remove the disc in the player, then insert a new one
Insert the compact disc with the label facing upward
Clean the disc or try to play a new one
Cool off or until the ambient temperature
returns to normal
Leave the player off for an hour, then try again
Adjust volume to a desired level
Check wiring connection
Adjust the installation angle less than 30 degrees
Clean the compact disc, then try to play a new one
Front panel is not properly fixed into its place
Press the RESET button.
Insert the antenna cable firmly
Select a station manually
Press the reset button to correct the problem. If the
error code does not disappear, consult your nearest
service dealer.
Replace the media device or format the SD/MMC card
Replace the media device or erase some un-usage files
Replace the disc or media device
replace the disc
Problem
No power
Disc cannot be
loaded or ejected
No sound
Sound skips
The operation keys do not work
The radio does not work
Error 1
Write error
Read error
Memory full
No file
Disc error
TROUBLESHOOTING
Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer.
Location Function
AB
1 Rear right (+) - Purple
2 Rear right (-) - Purple / Black stripe
3Front right (+) - Gray
4 Accu 12V(+) Front right (-) - Gray / Black stripe
5 Auto Antenna Front Left (+) - White
6Front Left (-) - White / Black stripe
7ACC+ Rear left (+) - Green
8Ground Rear Left (-) - Green / Black Stripe
DIALED LIST
TO FIND THE LAST 10 DIALED NUMBER
The unit can memory up to 10 last dialed number.
1.Press the volume knob (8), after the cursor is blinking press the volume
knob longer than 3 seconds.
2.The first number on the display will be the last dialed number. Rotate the
volume knob to navigate through the 10 last dialed numbers.
3.Press the volume knob (8) “DIAL” for longer than 3 seconds or press
button (9) “MODE” shortly to start dailing the number from the list.
4.You also can edit the number in the dialed list. If the dialed list is displayed
on the unit, press the volume knob (8) to enter the number edit mode.
Use the track up/down button to move the cursor back or forwardto the
numeric which want to edit.
NOTE:The unit only memorized the dialed numbers which dialed with the
unit, it cannot memorize the numbers dialing with the mobile phone.
HIGHLIGHT FEATURES
INCOMING CALL RINGING VOLUME (PHONE VOL)
Rotate the volume knob (8) to select the desired ringing volume from “00”
to “+38”.The default “Ringing volume level value” is “+20”.
AUTO ANSWER (A ANSWER)
Rotate the volume knob to select Auto answer “ON” or “OFF”. If “ON” is
selected the unit will automatically answer any incoming call without pressing
the phone button.
