694402
25
Verklein
Vergroot
Pagina terug
1/48
Pagina verder
25
WALL
3
PLUS - LEAN
3
PLUS - MOON - TILE
3
PLUS
EN
Fig. 46 - Ducting system example
If the stove is not tted with ducting system, it provide a hot air capacity ranging from a minimum of 60 m
3
/h
to a maximum of 130 m
3
/h with a temperature ranging between 90°C and 170°C.
For the ducting system, we recommend using a pipe with a maximum length of 6 mt and up to three 90°
elbows in order to maintain hot air temperature.
Use pipes with smooth internal surface and a diameter of 80 mm.
Fit the pipe with insulating material if it passes through a cold wall.
The outlet must be protected by a grid with wide mesh and a minimum total surface area of 40 cm
2
.
If the pipes used are longer than 6 mt, the air capacity ranges from a minimum of 58 m
3
/h to a maximum of
90 m
3
/h and the temperature from 65°C to 130°C. (These values refer to the laboratory used for the tests. The
room where the stove is installed may register different values both in terms of capacity and temperature).
If you wish to increase air capacity, install at the end of the pipe a small wall-mounted fan with a capacity
exceeding 130 m
3
/h. The installation must be carried out by an authorised technician.
According to the factory parameters, 1/2 of the generated heat is conveyed into the room where the stove
is installed, while the remaining 1/2 are conveyed through the left ducting pipe system.
Balance heat output with air capacity to obtain the best performance (see ). The operation above must be
carried out by an authorised technician.
11.14 STOVE CALIBRATION AND DEPRESSION MEASUREMENT
This stove has a pickup point positioned on the tank in order to measure the depression of the combustion
chamber and verify its proper operation.
To do this, proceed as follows:
Loosen nut "D" from the bottom of the stove, near the pressure switch (see Fig. 47 page 25.)
Connect a digital pressure switch with a tube to detect the negative pressure (see Fig. 48 page 25).
Load the feed screw via appropriate function.
Start the stove and set "Set_Flame" to power 1 (the start-up time of this stove lasts between 8 and 10 minutes
to ensure minimum draught).
Compare the read values with those on the table.
Change power every 10 minutes and wait for it to stabilise.
Access the user menu and, if necessary, change the parameters.
Fig. 47 - Casing removal Fig. 48 - Digital pressure switch connection
25

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Cadel Lean3 Plus bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Cadel Lean3 Plus in de taal/talen: Engels als bijlage per email.

De handleiding is 21,99 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Cadel Lean3 Plus

Cadel Lean3 Plus Gebruiksaanwijzing - Nederlands - 48 pagina's

Cadel Lean3 Plus Gebruiksaanwijzing - Deutsch - 48 pagina's

Cadel Lean3 Plus Gebruiksaanwijzing - Français - 52 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info