643525
44
Verklein
Vergroot
Pagina terug
1/56
Pagina verder
44
AQUOS - IBIS - IDRON
EN
14.15 ALARM RESET
To reset the alarm one must press and hold key 1 (ESC) for a few seconds. The boiler performs a check to
determine if the cause of the alarm persists or not.
In the rst case the alarm will still be displayed, in the second case it will go onto OFF.
If the alarm persists, contact the service centre.
14.16 NORMAL SHUTDOWN (ON THE PANEL: OFF WITH FLASHING FLAME)
If the shutdown key is pressed or if there is an alarm signal, the boiler goes into the thermal shutdown phase which
entails the automatic execution of the following stages:
It stops pellets loading
The room fan (if provided) maintains the set speed until the smoke T reaches 100°C, then it automatically sets
itself at the minimum speed until it reaches the shutdown temperature
The smoke fan sets itself at maximum speed and maintains it for a xed time of 10 minutes, at the end of which
if the smoke T has fallen below the shutdown threshold it switches off permanently, otherwise it sets itself at the
minimum speed until it reaches such threshold before switching off.
If the boiler was shutdown regularly but, due to thermal inertia the smoke temperature exceeds the threshold
again, the shutdown stage restarts at the minimum speed until the temperature goes down.
14.17 BLACKOUT WITH THE BOILER ON
In the event of a power cut (BLACKOUT) the boiler behaves as follows:
Blackout below 10”: it returns to its operation in progress;
In the event of a power cut that lasts over 10” with the boiler on or in the start-up stage, when the boiler is
powered again it goes back to the previous operating condition with the following procedure:
1) It cools down activating the smoke extractor at minimum power for 10’ and goes onto the next point;
1) It takes the boiler back to the operating condition before the blackout.
During stage 1 the panel displays ON BLACK OUT.
During stage 2 the panel displays Start-up.
If during stage 1 the boiler receives commands from the panel and thus carried out manually by the user, then
the boiler stops executing the blackout recovery status and proceeds to restart or shutdown as requested by
the command.
14.18 BLACKOUT ABOVE 10” WITH BOILER IN SHUTDOWN STAGE
In the event there is a power cut that lasts MORE THAN 10” with the boiler in the shutdown stage, when the
boiler is powered again it restarts in shutdown mode even if the smoke temperature has fallen under 45°C in the
meanwhile. This last stage can be skipped by pressing key 1 (esc) (it goes into start-up) and by pressing it again
(it recognises that the boiler is switched off).
15
MAINTENANCE AND CLEANING
Fig. 37 - Example of a clean brazier Fig. 38 - Example of a dirty brazier
ATTENTION!
All the cleaning operations of all parts must be performed with a completely cold product
and the plug disconnected.
The product requires little maintenance if used with certied high quality pellets.
44

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Cadel Ibis 15 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Cadel Ibis 15 in de taal/talen: Engels als bijlage per email.

De handleiding is 6,26 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Cadel Ibis 15

Cadel Ibis 15 Gebruiksaanwijzing en installatiehandleiding - Nederlands - 56 pagina's

Cadel Ibis 15 Gebruiksaanwijzing en installatiehandleiding - Deutsch - 56 pagina's

Cadel Ibis 15 Gebruiksaanwijzing en installatiehandleiding - Français - 56 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info