696858
41
Verklein
Vergroot
Pagina terug
1/72
Pagina verder
IDRO PRINCE
3
12-16-23-23 H
2
O - IDRO PRINCE 30-30 H
2
O - AQUOS
3
16-23-23 H
2
O - IDRON 16-22 AIRTIGHT - MIRA 16-22 -
TESIS 16-23
AIRTIGHT - HIDROFIRE 22.8
41
9 FIRST IGNITION WARNINGS
9.1 GENERAL WARNINGS
Remove all components that could burn (manual, various adhesive labels, and any polystyrene) from the product brazier and glass.
Make sure the brazier is positioned properly and rests solidly on the base.
The first ignition may fail, given that the feed screw is empty and is not always able to load the brazier in time
with the amount of pellets needed to ignite the flame.
CLEAR THE FAILED IGNITION ALARM CONDITION. REMOVE THE PELLETS IN THE BRAZIER AND REPEAT IGNITION.
If after several failed ignitions, there is still no flame even with normal pellet supply, make sure the brazier is positioned properly,
resting snugly in its housing without any ash build-up. If everything is as it should be, this means there might be a problem with
the product components or caused by improper installation.
REMOVE THE PELLETS FROM THE BRAZIER AND REQUEST ASSISTANCE FROM AN AUTHORISED TECHNICIAN.
Do not touch the stove during the first ignition, as the paint hardens during this phase. Touching the paint
could expose the steel surface.
If necessary, use the same colour spray paint for touch ups.
It is a good idea to ensure efficient ventilation in the room during the initial ignition, as the stove will give off
some smoke and the smell of paint.
ATTENTION!
Make sure pellets and ash have not accumulated in the brazier due to failed ignition. If the brazier is not clea-
ned before reattempting, there is the risk of further failed ignitions and even explosions in some cases.
Keep away from the stove and, as previously mentioned, air out the room. The smoke and the smell of paint will dissipate after
about an hour of operation; in any case, remember that they are not harmful to health.
The stove is subjected to expansion and contraction during the ignition and cooling phases; as such, it may make slight creaking
sounds.
This is absolutely normal, as the structure is built in laminated steel, and is not to be considered a defect.
It is extremely important to make sure not to overheat the stove right away, but rather heat it gradually to the desired tempera-
ture, initially using low power.
This will prevent damage to the ceramic plates or coil, welding, and steel structure.
DO NOT IMMEDIATELY EXPECT HEATING EFFICIENCY!!!
ATTENTION!
If smoke flows into the room from the appliance or the flue during operation or initial ignition, switch off the
device, air out the room, and immediately contact the installation/customer service technician.
41

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Cadel IDRO PRINCE 30 H2O bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Cadel IDRO PRINCE 30 H2O in de taal/talen: Engels als bijlage per email.

De handleiding is 2,7 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Cadel IDRO PRINCE 30 H2O

Cadel IDRO PRINCE 30 H2O Gebruiksaanwijzing - Nederlands - 72 pagina's

Cadel IDRO PRINCE 30 H2O Gebruiksaanwijzing - Deutsch - 76 pagina's

Cadel IDRO PRINCE 30 H2O Gebruiksaanwijzing - Français - 72 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info