560474
37
Verklein
Vergroot
Pagina terug
1/100
Pagina verder
BC10 basic controller 10
37
We reserve the right to make any changes due to technical modifications!
Installation and Servicing Instructions Logamax plus GB142-24/30/45/60 • Version 12/2004
Buderus Hydronic Systems • http://www.buderus.net
Resetting the appliance or resetting faults
If the appliance is down due to a fault, you can reset the
appliance by pressing the "Reset"
button. This is only
possible for so-called lock-out faults. There is another
type of fault, so-called blocking faults, that reset them-
selves when the cause has been remedied.
z Press the "Reset"
button to reset the appliance.
The display shows "U(" while resetting.
It is only possible to reset the appliance when a lock-out
code (blinking fault code) is visible in the display.
10.1.3 Displaying the heating system status and/or
faults
The display of the BC10 basic controller shows the
status of the heating system.
In the event of a fault the display immediately shows the
fault or the warning in the form of an error code (see
subsection 16.2). The status display will flash if the fault
is a lock-out fault.
z Press the "Service"
button to switch between
status displays or to read out the service and error
codes.
z Resolve the fault see subsection 16.3.
The following status displays can be seen depending on
the operating conditions:
U(
NOTICE
If the burner returns to fault mode after reset-
ting the appliance, you must resolve the fault
using the servicing section in this document.
Contact your supplier if necessary.
Displays
(examples)
Values Meaning Operating condition/Remedy
1
number
0 ... 199
Current heater water temperature (in °F)
> P15 Current system pressure (in psi) Normal operating conditions
1
(changing)
P3 ... P12 Warning:
System pressure is too low (between 3 and 12 psi
= 0.2 and 0.8 bar)
Warning
Heating system remains operational
between 12 psi and 3 psi (0.8 and 0.2 bar).
Fill the heating system and restore the
minimum filling pressure (t 14.5 psi =
t 1.0 bar).
The system pressure is shown for
10 minutes after which the standard
display returns.
number
0 ... 199
Current heater water temperature (in °F)
P3 ... P12 Current system pressure (in psi)
Table 9 Possible status displays
1
Standard display for this operating condition. This display appears after 5 minutes if no button is pressed.

3
+
3
+
+

3
37

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Buderus Logamax plus GB142-45 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Buderus Logamax plus GB142-45 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,63 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Buderus Logamax plus GB142-45

Buderus Logamax plus GB142-45 Gebruiksaanwijzing - Nederlands - 12 pagina's

Buderus Logamax plus GB142-45 Gebruiksaanwijzing - Deutsch - 16 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info