718739
118
Verklein
Vergroot
Pagina terug
1/132
Pagina verder
Troubleshooting
A-16
While sewing
Symptom Probable Cause Remedy Reference
Machine does not
operate.
“Start/Stop” button was not pressed. Press the “Start/Stop” button. B-33
The bobbin winder shaft is pushed to the right. Move the bobbin winder shaft to the left. B-13
There is no pattern selected. Select a pattern. B-32
Presser foot is not lowered. Lower the presser foot. B-33
“Start/Stop” button was pushed with the foot
controller attached.
Remove the foot controller, or use the foot
controller to operate the machine.
B-34
The “Start/Stop” button was pressed while the
machine is set for the sewing speed controller
to control the zigzag stitch width.
Use the foot controller instead of the “Start/
Stop” button to operate the machine, or press
to turn off the width control function.
B-34
Needle breaks.
Needle is installed incorrectly. Reinstall the needle correctly. B-27
Needle clamp screw is not tightened. Tighten the needle clamp screw. B-27
Needle is turned or bent. Replace the needle. B-27
Using improper needle or thread for the
selected fabric.
Check the “Fabric/Thread/Needle
Combinations” chart.
B-26
Wrong presser foot was used. Use the recommended presser foot. B-30
Upper thread tension is too tight. Adjust the thread tension setting. B-39
Fabric is pulled during sewing. Do not pull the fabric during sewing.
Spool cap is set incorrectly. Check the method for attaching the spool cap,
then reattach the spool cap.
B-13
There are scratches around the opening in the
needle plate.
* There is a notch on the left side of the
opening in the needle plate. This is not a
scratch.
1 Notch
Replace the needle plate, or consult your
authorized Brother dealer.
A-8
There are scratches around the opening in the
presser foot.
Replace the presser foot, or consult your
authorized Brother dealer.
B-29
There are scratches on the bobbin case. Replace the bobbin case, or consult your
authorized Brother dealer.
A-2
Needle is defective. Replace the needle. B-27
A bobbin designed specifically for this machine
is not used.
Incorrect bobbins will not work properly. Only
use a bobbin designed specifically for this
machine.
B-13
Upper threading is incorrect. Check the steps for threading the machine and
rethread the machine.
B-19
Bobbin is set incorrectly. Reset the bobbin thread correctly. B-16
Presser foot is attached incorrectly. Attach the presser foot correctly. B-29
Screw of the presser foot holder is loose. Securely tighten the screw of the presser foot. B-30
Fabric is too thick. Use fabric that the needle can pierce when the
handwheel is turned.
B-26, S-4
Fabric is fed forcefully when sewing thick fabric
or thick seams.
Allow the fabric to be fed without being
forcefully pushed.
S-4
a
118

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Brother-Innov-is-F410

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Brother Innov-is F410 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Brother Innov-is F410 in de taal/talen: Engels als bijlage per email.

De handleiding is 3,37 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Brother Innov-is F410

Brother Innov-is F410 Gebruiksaanwijzing - Nederlands - 132 pagina's

Brother Innov-is F410 Gebruiksaanwijzing - Deutsch - 132 pagina's

Brother Innov-is F410 Gebruiksaanwijzing - Français - 132 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info