767940
2
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
6. SAFETY NOTES
Please take the time to read these instructions carefully and keep them
to hand in the intended operating instructions compartment 17 on the
child safety seat at all times. The instructions must be kept with the child
safety seat if the latter is passed on to a third party.
In order for the SWINGFIX M i-SIZE to protect your child correctly, it must
always be installed and used exactly as described in these instructions.
It is possible that some of the child safety seat settings will lead to
restrictions when used in "i-Size" vehicle seat positions.
DANGER! For the protection of your child:
In the event of an accident with a collision speed of more than 10km/h, the
child safety seat may be damaged without the damage becoming immediately
visible. In this case the child safety seat must be replaced. Please dispose of
it properly.
• As a rule, have your child safety seat checked if it has been damaged
(e.g. if it falls on the ground).
• Regularly check all important parts for damage. Ensure that all mechanical
parts, in particular, are fully functional.
• Never lubricate or oil parts of the child safety seat.
Never leave your child unattended in the child safety seat in the vehicle.
• Only allow your child to enter and exit the vehicle on the pavement side.
Protect the child safety seat from intensive direct sunlight when it is not in use.
The child safety seat can get very hot in direct sunshine. Children's skin is
sensitive and could be harmed as a result.
• The more snugly the belt fi ts over your child's body, the better they will be
protected. Therefore, avoid putting thick clothes on your child under the belt.
Take regular breaks on long journeys in order to give your child the
opportunity to run about and play.
• Use on the rear seat: Move the front seat far enough forwards to ensure that
your child's feet cannot hit the backrest of the front seat (to prevent the risk
ofinjury).
DANGER! For the protection of all vehicle occupants:
In the case of an emergency stop or an accident, unsecured persons or objects
may cause injury to other vehicle occupants. Please always check that ...
• no other load-bearing contact points are used other than those specifi ed in
these instructions and marked out on the child safety seat.
• the backrests of the vehicle seats are locked (e.g. that a folding rear seat
bench latch is engaged).
• all heavy or sharp-edged objects in the vehicle (e.g. on the parcel shelf) are
secured.
• all persons in the vehicle have their seatbelts fastened.
• the child safety seat is always secured when it is in the vehicle, even if no
childis being transported.
WARNING! For your protection when handling the child seat:
• Never use the child safety seat free-standing, not even for test sitting.
• To avoid damage, ensure that the child safety seat is not jammed in between
hard objects (vehicle door, seat rails, etc.).
• Keep the child safety seat in a safe place when it is not in use. Do not place
any heavy objects on the seat and do not store it directly next to sources of
heat or in direct sunlight.
CAUTION! For the protection of your vehicle:
• Certain vehicle seat covers made from more sensitive materials (e.g. velour,
leather) may sustain signs of wear and tear when using child safety seats.
Foroptimum protection of your vehicle seat covers, we recommend using the
BRITAX RÖMER vehicle seat protector from our range of accessories.
PAGE II
1. If your vehicle is not fi tted with ISOFIX insertion aids as standard, clamp
the two insertion aids 02 , which are included in the scope of delivery of
the seat*, with the opening pointing upwards, to the two ISOFIX fastening
points 01 of your vehicle.
TIP! The ISOFIX fastening points are located between the surface and the
backrest of the vehicle seat.
2. Move the headrest of the vehicle seat into the top position.
* The insertion aids facilitate the installation of the child safety seat with the use
of the ISOFIX fastening points and prevent damage to the vehicle seat covers.
As long as they are not used, remove them and keep them in a safe place.
For vehicles with a folding backrest, the insertion aids need to be removed
before folding the backrest. Any problems occurring usually come from soiling
or external objects on the insertion aids and on the hook. Remove soiling or
external objects to rectify such problems.
7. PREPARATORY WORK
8. INSTALLATION OF THE CHILD
SAFETY SEAT
1. ADJUSTING THE SHOCK BAR
1.1 Place the child seat facing forwards (in the
direction of travel) on a suitable vehicle seat.
1.2 Press the adjustment handle 14 on the shock
bar 10 down with one hand and use the other
hand to pull the shock bar 10 up at the same
time, until it unlocks.
1.3 Adjust the angle of the shock bar 10 to the
angle of your vehicle seat backrest so the
shock bar 10 engages with a clicking sound.
9. USING THE CHILD SAFETY SEAT
2. PREPARING THE ISOFIX
2.1 Pull the grey fabric loop 15 until the ISOFIX
locking arms 16 are fully extended.
2.2 Push the green safety button 06 and the red
release button 05 on both sides of the seat
towards each other. This ensures that both
hooks on the ISOFIX locking arms 16 are
open and ready to use.
3. FASTENING THE ISOFIX
3.1 Position the two ISOFIX locking arms 16
directly in front of the two insertion aids 02 .
3.2 Push both ISOFIX locking arms 16 into the
insertion aids 02 until the ISOFIX locking
arms 16 engage on both sides with a clicking
sound.
DANGER! The green safety button 06
must be visible on both sides so that the child
safety seat is correctly fastened.
4. PUSHING THE CHILD SAFETY SEAT ON
SECURELY
Push the child safety seat as far as possible
towards the vehicle seat backrest.
5. CHECKING THE FASTENING
Shake the child safety seat to ensure that it is
securely fastened and check the safety buttons
06 to make sure that the two indicators are fully
green.
6. INSTALLING THE SUPPORT LEG
6.1 Pull the support leg 21 away from the back of
the child safety seat until you hear a click and
the support leg 21 is fully extended. The red
marking must not be visible any more.
6.2 Push both adjustment buttons 22 and pull
out the support leg 21 until it rests fi rmly on
the fl oor of the vehicle. The indicator on the
support leg 21 must be fully green and the
two adjustment buttons 22 must engage with
a clicking sound.
DANGER! The support leg 21 must
never be suspended in mid-air or supported
by other objects. Make sure that the support
leg 21 does not lift the SWINGFIX M i-SIZE
bottom section 19 up from the surface of the
vehicle seat.
1. LOOSENING THE SHOULDER STRAPS
To loosen the shoulder straps, press the strap
adjustment button 11 and, at the same time, pull
both shoulder straps 09 forwards.
CAUTION! Do not pull the shoulder pads 08 .
2. OPENING THE HARNESS BUCKLE
To open the harness buckle 04 , press the red
button on the harness buckle.
5. ADJUSTING THE HEADREST
A correctly adjusted headrest 03 ensures
optimum protection for your child in the child
safety seat:
The headrest 03 must be adjusted so that the
shoulder straps 09 are at the same level as your
child’s shoulders or slightly higher.
To adjust the headrest:
5.1 Loosen the harness (8.1).
5.2 Hold the release button 07 on the headrest
03 down and slide the headrest 03 until it is
at the correct shoulder strap height.
5.3 Check that the headrest 03 is properly
engaged by sliding the headrest 03 down
alittle.
3. POSITIONING A CHILD IN THE SEAT
Place your child in the child safety seat.
Make sure that the harness buckle 04 is folded
forwards and place your child in the child safety
seat.
DANGER! Only use the child safety seat
facing backwards on the passenger seat if the
front airbag has been deactivated.
4. FITTING THE SHOULDER STRAPS
Lay the shoulder straps 09 over your child's
shoulders.
CAUTION! The shoulder straps 09 must not
be twisted or have their places changed over.
6. CLOSING THE HARNESS BUCKLE
Push the two buckle tongues 29 together and
push them into the harness buckle 04 until they
engage with a clicking sound.
7. TENSIONING THE ADJUSTMENT STRAP
Pull the adjustment strap 12 until the strap lies fl at
and snug on your child’s body.
WARNING! The hip belt must lie as low as
possible over your child's hips.
1. Press the two adjustment buttons 22 on the support leg and push the
bottom part of the support leg into the top part until it is fully inserted.
Release the adjustment buttons to fi x the support leg in the inserted
position.
2. Loosen the ISOFIX fastening on both sides by pressing the green safety
button 06 and the red release button 05 towards each other.
3. Move the ISOFIX locking arms 16 back into the seat shell 18 .
TIP! The ISOFIX locking arms are protected against damage once they
are pushed back into the seat bottom.
DANGER! The child safety seat must always be secured when it is in the
vehicle, even if no child is being transported.
Please observe the waste disposal regulations in your country.
Disposal of packaging Container for cardboard boxes
Seat cover Residual waste, waste incineration
Plastic parts To be placed in the corresponding
container according to labelling
Metal parts Container for metals
Belt straps Container for polyester
Buckle and tongue Residual waste
10. ADJUSTING THE SEAT ANGLE
To adjust the seat angle:
Pull the adjustment handle 13 forwards and push/
slide the seat shell 18 into the desired position.
DANGER! The seat shell 18 must engage
securely with a clicking sound regardless of its
position. Pull up on the seat shell 18 to ensure that
itis engaged.
The shoulder straps 09 must be adjusted so that
they run horizontally or just above your child’s
shoulders.
The shoulder straps 09 are not allowed to run
behind your child’s back, or level with/above their
ears.
Before each car journey, in order to ensure your child’s
safety, make sure that ...
• the child safety seat is fastened in the ISOFIX fastening points
01
on both
sides with the ISOFIX locking arms
16
and both ISOFIX indicators
06
are
fully green;
12. DISPOSAL
11. REMOVING THE CHILD SAFETY SEAT
02
01
• the child safety seat is securely fastened;
• the support leg
21
is resting fi rmly on the fl oor of the vehicle and the
indicator on the support leg
21
is green;
• the rotating seat shell
18
is fully engaged and both indicators are black;
• the harness of the child safety seat is fi tted snugly to the child’s body
without being constricting;
• the shoulder straps
09
are correctly adjusted and the straps are not twisted;
• the shoulder pads
08
are in the correct position on your child’s body;
• the front airbag is deactivated if you are using the child safety seat on the
passenger seat;
• the buckle tongues
29
are fastened into the harness buckle
04
.
CAUTION! If your child tries to open the ISOFIX release buttons
05
or
the harness buckle
04
, stop immediately as soon as possible. Check
whether the child safety seat is correctly fastened and ensure that your
child is correctly secured. Explain to your child the dangers associated
with their actions.
13
18
The seat shell of the SWINGFIX M i-SIZE can be used in six di erent reclined
positions facing backwards:
12
03
07
03
09
09
04
04
14
10
15
16
05
06
16
02
06
21
22
22
19
11
09
08
04
29
04
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Britax-Romer SWINGFIX M i-SIZE bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Britax-Romer SWINGFIX M i-SIZE in de taal/talen: Engels als bijlage per email.

De handleiding is 2,05 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Britax-Romer SWINGFIX M i-SIZE

Britax-Romer SWINGFIX M i-SIZE Gebruiksaanwijzing - Nederlands - 2 pagina's

Britax-Romer SWINGFIX M i-SIZE Gebruiksaanwijzing - Deutsch - 2 pagina's

Britax-Romer SWINGFIX M i-SIZE Gebruiksaanwijzing - Français - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info