7. SAFETY NO
Please take the time to read these instructions carefully and keep
them to hand in the intended storage compartment 13 on the child
safety seat at all times! The instructions must be with the child safety
seat if the latter is passed on to a third party
DANGER! For the protection of your child:
In the event of an accident with a collision speed of more than 10 km/h,
the child safety seat may be damaged without the damage becoming
immediately visible. In this case the child safety seat must be replaced.
Please dispose of it properly
As a rule, have your child safety seat checked if it was damaged (e.g if it
falls on the ground).
Regularly check all important parts for damage. Ensure that all mechanical
parts, in particular
Never lubricate or oil parts of the child seat.
Never leave your child unattended in the child seat in the vehicle.
Only allow your child to enter and exit the vehicle on the pavement side.
Protect the child safety seat from intensive direct sunlight when it is not in
use. The child safety seat can get very hot in direct sunshine. Child skin is
sensitive and could thereby be harmed.
The more snugly the belt ¿ts over your child's body
tected. Therefore avoid putting thick clothes on your child under the belt.
T
tunity to play around.
Use on the rear seat: Move the front seat forward far enough that you
child's feet cannot hit the backrest of the front seat (to prevent risk of
injury).
DANGER! For the protection of all vehicle occupants:
In the case of an emergency stop or an accident, unsecured persons or
objects may cause injury to other vehicle occupants. Please always check
that...
the backrests of the vehicle seats are locked (i.e. that any foldable rear
seat bench latch is engaged).
all heavy or sharp-edged objects in the vehicle (e.g. on the parcel shelf)
are secured.
all persons in the vehicle have their seatbelts fastened.
the child safety seat is always secured when it is in the vehicle, even if no
child is being transported.
W
Never use the child safety seat free-standing, not even for test sitting.
:hen swivelling up the backrest 16 , nothing must come between the
backrest 16 and the seat cushion10 . Y
¿ngers, injuring them.
T
hard objects (car door
Keep the child safety seat in a safe place when it is not in use. Do not place
any heavy objects on the seat and do not store it directly next to sources of
heat or in direct sunlight.
CAUTION! T
Certain car seat covers made from more sensitive materials (e.g. velour
er
optimum protection of your car seat covers, we recommend using the BRIT
RÖMER car seat protector from our range of accessories.
P
A14 ensures that the diagonal seat belt section 18 is
optimally positioned, and gives your child optimum protection.
The headrest 14 must be adjusted so that there is a space two ¿ ngers wide
between the headrest 14 and your child's shoulders.
ToMust the height of the headrest to ¿t your
child:
1. Grip the adjustment handle 15 on the back of the
headrest 14 and pull it upwards.
This unlocks the headrest.
2. Y14 to
the desired height.
adjustment handle 15 , the headrest 14 will lock
into place.
3. Place the child safety seat on the vehicle seat.
4. Have your child sit down in the child safety seat and
check the height. Repeat the procedure until the
headrest 14 has the correct height.
8.
SECURING THE SICT
9. INST
With ISOFIT + 3-point belt
A
10. SECURING YOUR CHILD
14
15
14
With 3-point belt
B
7. Push both ISOFIT locking arms 07 into the insertion
aids 02 until the ISOFIT locking arm 07 engages
with a clicking sound.
DANGER ! Check that the ISOFIT locking arm is
correctly engaged 07 by pulling on it.
9. Press the red ISOFIT
08
to ensure
that the hook on the ISOFIT locking arm
07
is open
and ready for use.
10. Push both ISOFIT locking arms 07 into the
insertion aids 02 until the ISOFIT locking arm 07
engages with a clicking sound.
DANGER ! Check that the ISOFIT locking arm is
correctly engaged 07 by pulling on it.
11 Pull on the adjustment belt 12 and push the
child seat backwards at the same time, until the
die backrest 16 is À ush with the backrest of the
vehicle seat.
12. Give the child safety seat a ¿ rm pull forwards to
ensure that it is securely fastened and check the
ISOFIT locking arms again 07 to ensure that both
are fully locked in place.
13. Carry out the steps in Section 10 „ SECURING
YOUR CHILD“.
For the safety of your child, before every journey in the car check
that...
Źthe child safety seat is slotted in on both sides with the ISOFIT locking
arms 07 in the ISOFIT fastening points 01 ;
Ź the child safety seat is securely fastened;
Źthe lap belt 17 runs in the bright red belt guides on both sides of the seat
cushion 06 ,
Źthe diagonal seat belt section 18 on the side of the vehicle seatbelt buck-
le 19 also runs through the light red belt guide 06 of the seat cushion,
Źthe diagonal seat belt section 18 runs through the dark red belt holder 09
of the headrest,
Źthe SICT 03 isinstalled and used correctly
Źthe diagonal seat belt section 18 runs diagonally backward,
Źthe straps are tight and not twisted,
ŹThe seatbelt buckle 19 must not be positioned on the red belt guide 06 in
the seat cushion.
DANGER! If your child tries to open
the red ISOFIT safety button
08
or the vehicle belt buckle
19
, stop the vehicle as soon as safely possible.
Check whether the child safety seat is correctly fastened and ensure that
your child is correctly secured. Explain to your child the dangers associated
with his actions.
01
02
1. If your vehicle is not ¿ tted with ISOFIX insertion aids as standard, clamp
the two insertion aids 02 which are supplied with the seat* to the upward
pointing part of the two ISOFIX fastening points 01 of your vehicle.
TIP!
The ISOFIX fastening points are located between the surface and the back-
rest of the vehicle seat.
* The insertion aids facilitate the installation of the child safety seat with the use of the
SOFIX fastening points and prevent damage to the car seat covers.
are not used, remove them and keep them in a safe place. For vehicles with foldable
a backrest, the insertion aids need to be removed before folding the backrest.
problems occurring usually come from soiling or external objects on the insertion aids
and on the hook. Remove soiling or external objects to rectify such problems.
2. Moving the headrest of the vehicle seat into the top position.
3. Carry out the steps in Section 8 "ADJUSTING THE HEADREST & SE-
CURING THE SICT“.
The
KIDFIX SL / KIDFIX SL SICT
is installed permanently in the vehicle with the
ISOFIT locking arms.
Y
4. Place the child seat facing forward (in the direction
of travel) on a suitable vehicle seat.
5. Hold the ISOFIT adjustment button 11 down and
fully extend the ISOFIT locking arm furthest from
the vehicle door 07 .
6. Press the red ISOFIT
08
to ensure
that the hook on the ISOFIT locking arm
07
is open
and ready for use.
11
07
0807
16 12
8. Hold the ISOFIT adjustment button 11 down and
fully extend the ISOFIT locking arm nearest to the
vehicle door 07 .
UNF
T
in Section 6 „REMOV“ [PAGE I]
07
07
11
0807
07
1. Carry out the steps in Section 8 "ADJUSTING
THE HEADREST & SECURING THE SICT“.
2. Place the child seat on the vehicle seat. Ensure
that the backrest 16 is À ush with the backrest of
the vehicle seat.
Tip! If the headrest of the vehicle seat gets in the
way
3. Carry out the steps in Section 10 „SECURING
YOUR CHILD“.
For the safety of your child, before every journey in the car check
that...
Źthe child safety seat is securely fastened;
Źthe lap belt
17
runs in the bright red belt guides on both sides of the seat
cushion
06
,
Źthe diagonal seat belt section 18 on the side of the vehicle seatbelt buck-
le 19 also runs through the light red belt guide 06 of the seat cushion,
Źthe diagonal seat belt section 18 runs through the dark red belt holder 09
of the headrest,
Źthe diagonal seat belt section 18 runs diagonally backward,
Źthe straps are tight and not twisted,
Źthe SICT 03 is installed and used correctly
Źthe seatbelt buckle 19 must not be positioned on the red belt guide 06 in
the seat cushion.
DANGER! If your child tries to open the vehicle belt buckle 19 , stop the
vehicle as soon as safely possible. Check whether the child safety seat is
correctly fastened and ensure that your child is correctly secured. Explain
to your child the dangers associated with his actions.
UNF
T
steps in Section 6 „REMOV“ [PAGE I]
16
The
KIDFIX SL / KIDFIX SL SICT
is not installed permanently in the vehicle. It
is simply secured together with your child using the vehicle's 3-point seatbelt.
KIDFIX SL SICT & KIDFIX SL:
1.
2.
child to the vehicle seat buckle 19 .
DANGER! Ensure the vehicle belt is not twisted, as
otherwise the full protective effect of the
retaining system is not ensured.
3.
le 19 with a CLICK!
4. 18 and lap
belt section 17 on the side of the vehicle seatbelt
buckle 19 into the light red belt guide 06 of the seat
cushion.
DANGER! The vehicle seatbelt buckle 19 must
not be positioned between the light red
belt guide 06 and the armrest.
5. 17 on the other side
of the seat cushion in the light red belt guide 06 .
DANGER! The lap belt section 17 must lie as low
as possible over your child's hips on
both sides.
6. Guide the diagonal seat belt section 18 into the dark
red belt holder 09 of the headrest 14 until it lies
completely in the belt holder 09 and is not twisted.
Tip! If the backrest 16 conceals the belt holder 09 ,
you can adjust the headrest 14 upwards. The diagonal
seat belt section 18 can now be easily inserted. Now
return the headrest 14 to the proper height.
7. Make sure that the diagonal belt 18 runs over your
child's shoulder
Tip! Y
14 again here in the vehicle.
DANGER! The diagonal seat belt section 18 must
run diagonally backward. Y
adjust the course of the belt with your
vehicle's adjustable belt deÀ ector
DANGER! The diagonal belt 18 must never be di-
rected forwards to the belt deÀ ector on
the vehicle. In this case, use the child
safety seat on the back seat only
8.
onal seat belt section 18 .
9.
lation type.
19
18
17 06
19
17
06
18
18
18
09
14
19
ONL
Press the SICT 03 into both SICT fastening points on
the side of the child seat nearest the vehicle door 05
and clip in the SICT 03 .
CAUTION! Make sure that there is a gap of ap-
proximately 5 mm between the SICT
and the vehicle door in order to avoid
pressure marks and other damage to
the door trim.
03
05
How to secure the SICT
BRITAX RÖMER
Kindersicherheit GmbH
Blaubeurer Straße 71
D-89077 Ulm
Germany
T
F
E.: service.de@britax.com
www
BRITAX EXCELSIOR
LIMITED
1 Churchill Way West
Andover
Hampshire SP10 3UW
United Kingdom
T
F
E.:
service.uk@britax.com
www
If you have any further questions regarding its use, please feel free to
contact us:
16 14
150415_KIDFIX_SL_KIDFIX_SL_SICT_GB.indd 2 15.04.2015 08:23:32
