5
Step 1 - Attach the Lower Lat Tower to the Base
Platform
Locate the following items:
• Item #1 - Lower Lat Tower
• Item #2 - Base Platform
• Item #H - (4) 3/8" X 3" Button Head Screws
• Item #N - (8) 3/8" Washers
• Item #O - (4) 3/8" Nylock Nuts
Set the Base Platform (Item #2) onto the floor as shown
in Figure 1. Line up the bolt holes in the mounting channels
on the Lower Lat Tower (Item #1) with the holes in the Base
Platform tubes.
Place (4) 3/8" Washers (Item #N) over the ends of (4) 3/8" X 3"
Button Head Screws (Item #H) - one washer per screw.
Insert the forward screws through the bolt holes in the Lower
Lat Tower and Base Platform first, then tip the Base Platform
back to install rear screws. Place (4) 3/8" Washers over the
ends of the screws, one washer per screw, and secure using
(4) 3/8" Nylock Nuts (Item #O), as shown in Figure 1
.
Completely tighten hardware installed during Step 1.
3
Figure 2
E
Base Platform/
Lower Lat
Tower
Assembly
N
Stems
Tube
Ends
Stems
Pulleys
4
2
Figure 1
H
N
O
Mounting
Channels
Base Platform
Tubes
Forward
Screws
1
Step 2 - Attach the Base Legs to the Base Platform
Locate the following items:
• From Step 1 - Base Platform/Lower Lat Tower Assembly
• Item #3 - Base Right Leg - Do not unwrap cables!
• Item #4 - Base Left Leg - Do not unwrap cables!
• Item #E - (4) 3/8" X 3/4" Button Head Screws
• Item #N - (4) 3/8" Washers
With the Base Platform/Lower Lat Tower Assembly (from
Step 1) on the floor, insert the stems from each Base Leg
into the tube ends on the Base Platform, as shown in Figure
2. Make sure to orient the 2 pulleys upward.
Carefully line up the two bolt holes on each Leg with the
corresponding holes on the Base Platform/Lower Lat Tower
Assembly.
Place (4) 3/8" Washers (Item #N) over the ends of (4) 3/8" X 3/4"
Button Head Screws (Item #E) - one washer per screw. Loosely
secure the Base Legs to the Base Platform Assembly with the
screws and washers as shown in Figure 2.
Completely tighten hardware installed during Step 2.
Assembly Guide
