Information on laundry ...
Labelling of fabrics
Follow the manufacturer's care information.
( Drying at normal temperature.
'cDrying at low temperature a also select V Reduce Heat.
)cDo not machine dry.
Observe safety instructions without fail a Page 11!
Do not tumble-dry the following fabrics for example:
Impermeable fabrics (e.g. rubber-coated fabrics).
Delicate materials (silk or curtains made from synthetic material) a they may crease.
Dripping wet washing high a energy consumption!
Laundry contaminated with oil.
Drying tips
To ensure a consistent result, sort the laundry by fabric type and drying programme.
Always dry very small items (e.g. baby socks) together with large items of laundry (e.g. hand
towel).
Close zips, hooks and eyelets, and button up covers.
Tie fabric belts, apron strings, etc. together
Do not over-dry easy-care laundry a risk of creasing!
Allow laundry to finish drying in the air.
Do not dry woolens in the dryer, only use to freshen them up a Page 7, Woollens finish
Programme (depending on model).
Do not iron laundry immediately after drying, fold items up and leave for a while a the
remaining moisture will then be distributed evenly.
The drying result depends on the type of water used during washing. a Fine adjustment
of the drying result a Page 6.
Machine-knitted fabrics (e.g. T-shirts or jerseys) often shrink the first time they are dried a
do not use the +: Extra Dry programme.
Starched laundry is not always suitable for dryers a starch leaves behind a coating that
adversely affects the drying operation.
Use the correct dosage of fabric softener as per the manufacturer's instructions when
washing the laundry to be dried.
Use the timer programme for small loads a this improves the drying result.
Environmental protection / Energy-saving tips
Before drying, spin the laundry thoroughly in the washing machine a the higher the spin
speed the shorter the drying time will be (consumes less energy), also spin easy-care
laundry.
Put in, but do not exceed, the maximum recommended quantity of laundry a
programme overview a Page 7.
Make sure the room is well ventilated during drying.
Clean the fluff filter after every drying cycle a Page 4.
Do not obstruct or seal up the air inlet.
Ĕ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
ʋ
. đ
a
ˎ V '
L I a
a
Care and cleaning
Dryer housing, Control panel, Air inlet, Moisture sensors
Wipe off with a soft, damp cloth.
Do not use abrasive cleaners or solvents.
Remove detergent and cleaning agent residue immediately.
Exhaust air duct
Check the exhaust air duct. Clean the exhaust air duct every six months.
Do not bend the exhaust air duct.
1. Switch off the dryer and allow it to cool down.
2. Disconnect the mains plug.
3. Remove the exhaust air duct.
4. Clean the exhaust air duct.
5. Refit the exhaust air duct a Installation instructions for exhaust air duct.
Moisture sensors
The dryer is equipped with stainless steel moisture sensors.
Moisture sensors measure the moisture level of the laundry.
After sustained, repeated operation, a fine layer of limescale may form
on the moisture sensors.
1. Open the door.
2. Clean the moisture sensors using a slightly damp sponge with a rough
surface.
Do not use steel wool or abrasive materials.
Only when switched off!
Fine adjustment of the drying result
Adjustment of the levels of dryness
üüüüü
