362550
38
Verklein
Vergroot
Pagina terug
1/132
Pagina verder
34
deen
Dispensing hot water
! Risk of burns
The milk frother 10 gets very hot. After use,
allow to cool down first before touching.
The appliance must be ready for use.
Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
Select the required setting for hot water
Ê
by turning the knob 6.
Press the
start
button 8. Hot water runs
out of the milk frother outlet 10 for about
40 seconds.
Press the
start
button 8 again to cut the
process short.
N.B.: It is possible to set the temperature of
the hot water (see “Controls, °
C
button”).
Maintenance and daily
cleaning
! Risk of electric shock
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
Wipe the outside of the appliance with a
soft, damp cloth. Do not use abrasive
cloths or cleaning agents.
Rinse the water tank 11 and the brewing
unit 23 with water only.
The cover of the storage compartment
25, the drip tray panel 26 and the cover of
the milk container 31 should only be
wiped gently with a damp cloth. Do not
put them in the dishwasher.
Remove cup stand 28. Pull the drip tray
27 with the coffee grounds container 29
forward and out, then empty and clean
them. All the parts can also be cleaned
in the dishwasher.
Clean the measuring spoon 14, the
aroma cover 16 and the milk container 31
by hand or in the dishwasher.
Wipe out the inside of the appliance (tray
holders).
Important:
The drip tray 27 should be
emptied and cleaned daily to prevent mould
from developing.
N.B.: If the appliance is cold when switched
on with the
a button 2, or if it is set to a
mode after brewing coffee, it rinses
automatically, in other words the system
cleans itself.
Cleaning the milk system
Clean the milk system 10 immediately after
use!
The milk system 10 can be pre-cleaned
automatically.
Select the
Ì
symbol in the display 5 and
press the
start
button 8.
PLACE EMPTY GLASS UNDER FROTHER,
P
LACE SUCTION PIPE IN GLASS
START
Place an empty glass under the milk
system 10 and put the end of the pipe
10d in the glass.
Press the
start
button 8. The appliance
now fills the glass automatically with
water and draws it in again through the
pipe 10d for cleaning. The rinse
procedure stops automatically after about
1 minute.
Now empty the glass and clean the pipe
10d.
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).
Dismantling the milk system 10 for
cleaning:
Pull the milk system 10 forward out of the
appliance.
Clean the individual parts (Fig. C) with a
detergent solution and a soft brush.
Rinse all parts with clear water and dry
them.
Reassemble all the parts and replace fully
in the appliance.
Note: All the parts of the milk frother 10 can
also be put in the dishwasher.
38

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Bosch-tca-7301-vero-professional-300

Zoeken resetten

  • me koffiezetapparaat blijft zeggen bonen resovaar vullen terwel de bonen vol zitten en hebben hem al helemaal schoon gemaakt en ontkalkt wat zou dit kunne zijn Gesteld op 25-5-2015 om 09:57

    Reageer op deze vraag Misbruik melden
    • HALLO

      IK HEB SOMS HETZELFDE PROBLEEM, BRAND MN BONEN ZELF
      SOMS ZIJN ZE TE 'GLAD' VOOR HET TRANSPORTMECHANISME, TE DONKER EN OLIE ACHTIG

      SLA ZE IN EEN THEEDOEK HALF KAPOT EN HEB ER DAN GEEN LAST MEER VAN

      SUCCES, HOOP DAT HET HELPT

      HANS Geantwoord op 25-5-2015 om 13:08

      Waardeer dit antwoord (1) Misbruik melden
  • hallo,

    wij hebben een vero professional 100 en daarvan loopt de molen sinds gisteren continu!
    zodra ik de stekker in het stopcontact stop begint de molen te draaien terwijl jet apparaat nog niet eens aanstaat.
    wie kan ons helpen hoe dit op te lossen is? Gesteld op 5-3-2014 om 11:56

    Reageer op deze vraag Misbruik melden
    • Hallo

      Staat het rode palletje wel goed op de cassette binnenin? Ik bedoel dat dingetje wat je naar voren drukt om de cassette eruit te halen en als je hem terug plaats moet je hem vergrendelen door het palletje naar achteren te drukken. We hebben hetzelfde probleem gehad. Daarna deed hij het weer namelijk. Er zat eerst iets scheef zodat het palletje niet goed pastte. Hopelijk heeft u hier iets aan. Geantwoord op 5-3-2014 om 12:20

      Waardeer dit antwoord Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bosch tca 7301 vero professional 300 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bosch tca 7301 vero professional 300 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans als bijlage per email.

De handleiding is 4,45 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info