Setting up
Figure 2
a) Push the hose connector into the opening on the vacuum
cleaner until it engages.
b) To remove the hose, press the two lugs together and pull
the hose out.
Figure 3*
Connect the handle and suction hose/telescopic tube
together.
Figure 4*
Connect the floor tool and suction hose/telescopic tube
together.
Figure 5*
a) Connect the suction hoses together.
b) Disconnect the telescopic tube and unlock it to adjust its
length by moving the sliding button/sliding sleeve in the
direction of the arrow.
Figure 6
Holding the power cord by the plug, pull out the required
length and plug it into the mains socket.
Figure 7
Press the on/off button in the direction of the arrow to
switch your vacuum cleaner on/off.
Figure 8*
a) Adjust the suction by turning the on/off button in the
direction of the arrow.
b) The suction can also be regulated by adjusting the air
flow regulator in the direction of the arrow.
Ⅲ
Auxiliary air opening open
=> Suction is reduced
Ⅲ
Auxiliary air opening closed
=> Maximum suction
Vacuuming
Figure 9
Adjusting the floor tool:
Ⅲ
Rugs and carpets =>
Ⅲ
hard floors =>
Disposal information
Packaging
The packaging is designed to protect the vacuum
cleaner from being damaged during transportation. It
is made of environmentally friendly materials and can
be recycled.
Dispose of packaging that is no longer required at an
appropriate recycling point.
Used vacuum cleaners
Used vacuum cleaners still contain many valuable
materials. Therefore, please take your used vacuum
cleaner to your retailer or recycling centre to be
recycled. For current disposal methods, please
enquire at your retailer or your local council.
Disposal of filters and dust bags
Filters and dust bags are made from environmentally
friendly materials.
As long as they do not contain substances that are
not permitted to be disposed of in the household
rubbish, you can dispose of them with your normal
household rubbish.
!
Please note
The mains socket must be protected by at least a 16
amp fuse.
If a fuse should blow when you switch on the
appliance, this may be because other electrical
appliances which have a high current draw are
connected to the same power circuit.
To prevent the fuse from blowing, select the lowest
power setting before switching the appliance on, and
increase the power only once it
is running.
Fold out picture pages.
Before using for the first time
Figure 1*
Push the handle onto the flexible tube and until it
engages.
en
7
