10
Finish in
When you select a programme, the respective programme duration is displayed. You can delay
the start of the programme before it begins. The finish-in time indicates when the programme will
be finished. It can be set in hour increments up to a maximum of 24 h.
Press and hold the Finish in button until the required number of hours is shown (h=hour).
Select Start/Reload $, theâdoor is locked.
cSpin speed
You can change the indicated spin speed. The maximum spin speed which can be selected
depends on the chosen programme. If is selected, the load is held in the rinsing water.
{ Dry
You can activate, deactivate and set the drying function by touching this option button. Mode
ofâwashing and drying without interruption is auto dry only; when single drying programme
isâselected, you can choose auto dry, or time dry with desired drying time. aPage 8
ʑ
Additional functions
See also Programme overview aPage 7
7 Prewash For heavily soiled laundry. Prewash at max. 30°C.
2
Rinse Plus
Additional rinse cycle. Prolonged programme duration. For
areas with very soft water or for further improving the washing
result.
S
Less Iron
Special spin sequence with subsequent fluffing. Gentle final
spin residual moisture in the laundry increased slightly.
ccIntensive
Extends the washing time for a more intensive washing
ofâheavily soiled items.
ʑ
Start/Reload $
For starting or pausing the washing/drying programme.
ʑ
Signal volume (for button signal and information signal)
ʑ
Childproof lock # Programme will not be changed by accidental operation.
To activate the childproof lock:
After the programme starts or finish in time being activated aPage 10, press and hold the
Finish in button for 5 seconds.;
Release when the # symbol lights up. If button signal is on, an acoustic signal will be heard.
When the programme ends, the Start/Reload $ indicator remains on to remind you to
deactivate the childproof lock.
To deactivate the childproof lock:
Touch the Finish in
button until the # symbol turns off.
Release the button.
# symbol flashes if the programme has been changed while childproof lock is activated.
Ifâthe childproof lock is deactivated while the programme selector is in a different position from
when the childproof lock was activated, the running programme will be halted.
11
Please close the door immediately because of rising water level.
In pause status and are displayed alternately.
Door is locked for safety reasons (water level and/or temperature are too high).
For washing programme: In pause status, and are displayed alternately. If
you need to open the door, wait for the temperature to drop or drain the water (e.g. select
Rinse/Spin «/ or Drain > programme).
For drying programme: If you need to open the door, wait for the temperature to drop or
set drying programme for 15 minutes to cool down the laundry.
If is frequently indicated when the drying programme ends:
Clean the air inlet filter. aInstallation and maintenance instructions, Page 9
Run the Fluff Clean .÷: (cold) programme without laundry.
Door cannot be locked/unlocked due to high temperature of the door lock. Keep the
machine switched on for about 1 minute. Then the machine can be locked/unlocked again.
Door cannot be opened due to the high temperature after the drying programme.
The cooling down process will continue until this display disappears and the door can be
opened.
Flashing (no water supply):
Tap turned on?
Inlet filter blocked? Clean filter. aInstallation
and maintenance instructions, Page 8
Supply hose kinked or blocked?
On (low water pressure):
Only information. No influence on the
programme process. The programme
duration will be prolonged.
Clean drain pump. aInstallation and maintenance instructions, Page 8;
outlet pipe/drainage hose blocked.
Hold down the { (Dry) button for 3 seconds to clear this display.
Clean the air inlet filter. aInstallation and maintenance instructions, Page 9
Run the Fluff Clean .÷: (cold) programme without laundry.
other displays
Switch off the appliance, wait 5 seconds and switch it back on.
If the display appears again, call the customer service.
Safety instructions
Read and follow the operating and Installation and maintenance instructions and all other
information enclosed with the washer dryer.
Retain documents for subsequent use.
Risk of electric
shock
Never pull out the mains plug by tugging the power cord.
Never insert/pull out the mains plug with damp hands.
Risk of death For worn-out appliances:
Pull out the mains plug.
Sever the power cord and discard together with the plug.
Destroy the lock on the washer dryer door. This will prevent children from
locking themselves in and risking their lives.
Risk of suffocation Keep packaging, plastic film and packaging parts out of the reach
ofâchildren.
Risk of poisioning Keep detergents and care products out of the reach of children.
Risk of explosion Items of laundry pretreated with cleaning agents containing solvents, e.g.
stain remover/cleaning solvents may lead to an explosion after being
loaded into the washer dryer.
Rinse items of laundry thoroughly by hand before.
Risk of injury Washer dryer door may become very hot.
Take care when draining hot detergent solution.
Do not climb onto the washer dryer.
Do not lean on the open washer dryer door.
Do not touch the drum in case it is still spinning.
Ensure that the pump cap is screwed on while the machine is running to
prevent the escape of water and contact with moving pump parts.
If a drying programme was interrupted, the washer dryer and the laundry
may be very hot, select Intensive Dry {cor Gentle Dry 8 and set 15
minutes programme to cool down the laundry, then remove the
laundry.
Information on the display
