Handleiding Bosch WIS24141 - 8 Logixx (pagina 2 van 8) (Engels)

550925

Verklein

Vergroot

Pagina terug

1/8

Pagina verder

Overview of programmes aObserve table of consumption values on Page 8 and instructions on Page 6!

Programmes °C max.

Type

Additonal functions; information

L Cottons 20 - 90 °C

7 kg *

Hard-wearing textiles, heat-resistant textiles

made of cotton or linen

Eco

, 7 Prewash, S Reduced Ironing, = Aqua Plus

L Cottons ~ 40, 60 °C

 Easy-Care 30 - 60 °C

3.5 kg *

Easy-care textiles made of cotton, linen, synthetic

fibres or blended fabrics

Eco

, 7 Prewash, S Reduced Ironing, = Aqua Plus

/ Mixed Load

30 °C Textiles made of cotton or easy-care textiles

Eco

, 7 Prewash, S Reduced Ironing, = Aqua Plus

Different types of washing can be washed together

 Delicates/Silk 30 °C

2 kg

For delicate, washable textiles, e.g. made of silk,

satin, synthetic fibres or blended fabrics

(e.g. curtains)

Eco

, 7 Prewash, S Reduced Ironing, = Aqua Plus

No spin cycle between the rinse cycles

: Wool cold, 30 °C

Hand or machine-washable wool or rich-wool

textiles

Especially gentle wash programme to prevent shrinkage, longer

programme pauses (textiles rest in wash liquor)

Additional programmes 2 Rinse/Freshen Up,  Spin, = Drain

 The programmes are time-controlled for lightly soiled textiles. If textiles are heavily soiled, reduce the load or select additional function, e.g. Eco

.

When washing at maximum load using programmes marked with *, always select  Eco

 additional function.

Irrespective of the type of washing,  Easy-Care 40 °C at max. selectable spin speed is best suited as a short programme.

Programmes without Prewash – pour detergent into dispenser II, programmes with Prewash – divide detergent between dispensers I and II.

9401 / 9000959112

*959112*

WIS24141GB

Robert Bosch Hausgeräte GmbH

Carl-Wery-Str. 34

81739 München/Deutschland

Safety instructions

– Read and follow the operating and installation instructions and all other information

enclosed with the washing machine.

– Retain documents for subsequent use.

Risk of electric shock

– Never pull out the mains plug by tugging the power cord!

– Insert/pull out the mains plug with dry hands only.

Danger to life

On redundant appliances:

– Pull out the mains plug!

– Sever the power cord and discard together with the plug.

– Destroy the lock on the washing-machine door. This will prevent

children from locking themselves in and suffocating.

Risk of suffocation

– Keep packaging, plastic film and packaging parts out of the reach

of children.

Risk of poisioning

– Keep detergents and care products out of the reach of children.

Risk of explosion

– Caused by detergents containing solvents, e.g. stain remover/

items of washing pretreated with solvent naphtha may result in an

explosion after being loaded into the washing machine.

Before hand thoroughly rinse items of washing by hand.

Risk of injury

– Washing machine door may become very hot.

– Caution when draining hot detergent solution.

– Do not climb on the washing machine.

– Do not lean on the open washing machine door.

– Do not reach into the drum in case it is still rotating.

Consumption values

Programme Additonal function Load Current*** Water***

Programme

duration

***

L Cottons 20 °C

- 7 kg 0,21 kWh 77 l 1 @ h

L Cottons 40 °C*

 Eco



7 kg 0,78 kWh 77 l 2 @ h

L Cottons 60 °C

- 7 kg 1,30 kWh 77 l 1 B h

L Cottons 90 °C

- 7 kg 2,26 kWh 90 l 2 h

 Easy-Care 40 °C*

 Eco



3,5 kg 0,58 kWh 57 l 1 @ h

 Delicates/Silk 30 °C

- 2,0 kg 0,17 kWh 30 l B h

: Wool 30 °C

- 2,0 kg 0,20 kWh 40 l B h

* Programme setting for test according to currently valid European standard 60456.

Information about comparability tests:

To test the test programmes, wash indicated load, with  Eco

 additional function

and at maximum selectable spin speed.

Programme Additonal function Load

Annual energy

consumption

Annual water

consumption

L Cottons Eco ~

Eco

**

7/3.5 kg 220 kWh 11000 l

** Programme setting for testing and energy labelling according to directive 2010/30/EU with cold

water (15 °C).

***The values deviate from the indicated values depending on water pressure, water hardness, water

inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised

detergent, fluctuations in the mains voltage and selected additional functions.

Insert for liquid detergent depending on model

Position insert for dosing liquid detergent:

– Completely remove detergent drawer. aPage 10

– Push insert forwards.

Do not use insert (push upwards):

– For gel-like detergents and washing powders,

– For programmes with 7 Prewash.

Care

Machine housing, control panel

– Remove detergent residue immediately.

– Wipe with a soft, damp cloth.

– Do not clean the appliance with a water jet.

Clean the detergent drawer ...

... if it contains detergent or fabric softener residue.

1. Pull out, depress insert, take out drawer all the way.

2. Take out insert: using your finger, press insert upwards.

3. Clean detergent dispenser and insert with water and a brush and dry.

4. Attach insert and lock into position (push cylinder onto guide pin).

5. Slide in the detergent dispenser.

Leave detergent drawer open so that residual water can evaporate.

Drum

Leave washing machine door open so that the drum can dry out.

Use chlorine-free cleaning agent, not steel wool.

Descaling No washing in the machine!

Not required if detergent dosed correctly. However, if this does occur, follow the instructions

of the descaling agent manufacturer. Suitable descalers can be purchased on our website

or from customer service.

Information about the indicator lights depending on model

A signal sounds and the indicator lamps for spin speed and status displays flash:

Close the washing

machine door

properly;

washing may

be caught.

Turn on tap fully, supply

hose kinked/jammed;

clean filter aPage 10,

water pressure too low.

Drain pump blocked;

clean drain pump.

aPage 10

Drainage hose/outlet

pipe blocked; clean

drainage hose on the

siphon. aPage 10

Water in the base

pan, appliance

leaking. Call

customer service!

Motor fault. Call

customer service!

Other displays: Switch off appliance, wait 5 seconds and switch on again.

If the display is indicated again, call customer service. aInstallation Instructions

– Risk of electric shock! Pull out the mains plug!

– Risk of explosion! No solvents!

Maintenance

Detergent-solution pump

Set programme selector to Off, pull out the mains plug.

1. Take the drainage hose out of the holder.

Remove sealing cap, allow detergent solution to flow out.

Put the closing cap back on the hose.

2. Carefully unscrew the pump cover (residual water).

3. Clean the interior, pump cover thread and pump housing

(fan impeller in the detergent-solution pump must rotate).

4. Reinsert and screw on pump cover.

Handle is upright. Insert the drain hose into the holder.

To prevent unused detergent from flowing into the outlet during the next wash:

Pour 1 litre of water into dispenser II and start the > Drain programme.

Drainage hose on the siphon

Set programme selector to Off, pull out the mains plug.

1. Loosen hose clip, carefully remove drainage hose (residual water).

2. Clean drainage hose and siphon spigot.

3. Re-attach drainage hose and secure connection point with hose clip.

Filter in the water inlet hose

Risk of electric shock!

Do not immerse Aqua-Stop safety device in water (contains electric valve).

Release water pressure in the supply hose:

1. Turn off the tap!

2. Select any programme (except  Spin/> Drain).

3. Select $ Start/Pause. Leave programme for approx. 40 seconds.

4. Turn the programme selector to Off. Pull out the mains plug!

Clean the filter:

5. Disconnect the hose from the water tap.

Clean filter with small brush.

and/or for standard and Aqua-Secure models:

Remove hose from the rear of the appliance.

Take out filter with pliers and clean.

6. Connect the hose and check for leaks.

– Risk of scalding!

Allow detergent solution to cool down!

– Turn off the tap!

What to do if …

Water is running out. – Correctly attach/replace drainage hose.

– Tighten screw-fitting on the supply hose.

Water not flowing in.

Detergent not washed in.

– $ Start/Pause not selected?

– Tap not open?

– Filter blocked? Clean the filter. aPage 10

– Supply hose kinked or jammed?

Washing-machine door

cannot be opened.

– Safety function active. Stop programme? aPage 4

– Rinse Hold (without final spin) selected? aPage 3, 4

– Can be opened via emergency release only? aPage 6

Programme does not start. – $ Start/Pause not selected?

– Door closed?

Detergent solution is not

drained.

– Rinse Hold (without final spin) selected? a Page 3, 4

– Clean the drain pump. aPage 10

– Clean outlet pipe and/or drainage hose.

Water not visible in the

drum.

– Not a fault – water below the visible area.

Spin result not satisfactory,

washing wet/too damp:

– Not a fault – unbalanced load detection system has stopped the spin

cycle, washing unevenly distributed.

Distribute small and large items of washing in the drum.

– S Reduced Ironing is selected? aPage 5

– Too low speed selected? aPage 5

The programme duration

changes during the wash

cycle.

– Not a fault – the programme sequence is optimised for the particular

wash process. This may result in changes to the programme duration

in the display field.

Spin cycle actuated several

times.

– Not a fault – unbalanced load detection system adjusts imbalance.

Residual water in the

dispenser for care

product ~.

– Not a fault – effect of the care product not impaired.

– If required, clean insert. aPage 9

Odour formation in the

washing machine.

– Run L Cottons 90 °C programme without washing.

Use standard detergent.

Foam is coming out of the

detergent drawer.

– Too much detergent used?

Mix 1 tablespoon of fabric softener with ½ litre of water and pour into

dispenser II (not for outdoor, sports and down-filled textiles!).

– Reduce detergent dosage for the next wash cycle.

Loud noise formation,

vibrations and “Wandering”

during spin cycle.

– Appliance feet fixed?

Secure appliance feet. aInstallation Instructions

– Transportation protection devices removed?

Remove transportation protection devices. aInstallation Instructions

Noises during spin

and drain cycles.

– Clean the drain pump. aPage 10

Indicator lights do not

function while the

appliance is running.

– Power failure?

– Fuse tripped? Switch on/replace fuse.

– If the fault occurs repeatedly, call customer service.

The programme takes

longer than usual.

– Not a fault – unbalanced load detection system adjusts imbalance

by repeatedly distributing the washing.

– Not a fault – foam detection system active – a rinse cycle is

switched on.

Detergent residue on the

washing.

– Occasionally phosphate-free detergents contain water-insoluble

residue.

– Select 2 Rinse/Freshen Up or brush the laundry after washing.

In the pause status

$ Start/Pause flashes

very quickly and a signal

sounds.

– Water level too high. Washing cannot be reloaded.

Immediately close washing machine door.

– Select $ Start/Pause to continue the programme.

If a fault cannot be rectified (switching the machine on and off) or a repair is required:

– Set programme selector to Off and pull out the mains plug.

– Turn off the tap and call customer service. aInstallation Instructions

en operating instructions

Washing machine

WIS24141GB

Observe the safety instructions on page 8

Read these instructions and the separate installation instructions before

operating the washing machine

Bosch WIS24141 - 8 Logixx Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info