en Operating the appliance
22
Note
- for environmentally friendly operation
of the dishwasher:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
“Standard programme” which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display )".
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
Timer programming
Timer programming *
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button @ + until the digital
display )" jumps to œ:‹‚.
4. Press @ + or – button until the
displayed time corresponds with your
requirements.
5. Press START button P, timer
programming is activated.
6. To delete timer programming, press
the @ + or – button until )" œ:‹‹
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value ‹:‹‹ is indicated on the numerical
display )".
Switching off automatically
after the end of
the programme *
Switching off automatically after the end of the programme
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the
programme ends (factory setting).
Automatic disconnection
can be adjusted from ˜:‹‹ to ˜:‹ƒ.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button P
until •:‹... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display )" displays the
factory setting •:‹….
5. Press programme button # until
the factory set value ˜:‹‚
is indicated on the digital
display )".
˜:‹‹ Appliance does not switch off
automatically
˜:‹‚ Off after 1 min
˜:‹ƒ Off after 120 min
