Operating the appliance en
23
m Warning – Risk of injury!
Do not touch the blow opening 1R. The
blow opening becomes hot and,
furthermore, any damage will result in
a chargeable callout by customer
service.
Switching on the appliance
1. Turn on the tap fully.
2. Open the door.
3. Switch on ON/OFF switch (.
The Eco 50° programme display
flashes. This programme remains
selected if no other programme
button 0 is pressed. The expected
programme duration
flashes on the digital display 8.
4. Press the START button )".
5. Close the door.
The programme starts running.
Note
- for environmentally friendly operation
of the dishwasher:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
“Standard programme” which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display 8.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
Onboard computer
You can switch the onboard computer
(additional programme information) off
or on. Proceed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button )"
until •:‹... is indicated on the digital
display 8.
4. Release both buttons.
The LED for button # flashes
and the digital display 8 displays
the factory setting •:‹….
5. Press programme button # until
the factory set value ’:‹‹
is indicated on the digital
display 8.
To change the setting:
1. By pressing the 3 button, you can
switch the on board computer
(additional programme
information) off ’:‹‹ or on ’:‹‚.
2. Press START button )".
The set value is saved.
3. Close the door.
