Operating the appliance en
23
Programme sequence indicator
Programme sequence
indicator )"
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display )*.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
Programme TurboSpeed 20 min.:
During the heating up phase • and the
remaining running time are indicated
alternately on the digital display; at the
end p flashes, indicating that the
appliance can be opened and loaded.
When the appliance has been restarted,
the remaining running time is indicated
again during the rinsing phase.
Timer programming
Timer programming *
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button X + until the digital
display )* jumps to œ:‹‚.
4. Press X + or – button until the
displayed time corresponds with your
requirements.
5. Press START button h, timer
programming is activated.
6. To delete timer programming, press
the X + or – button until )* œ:‹‹
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value ‹:‹‹ is indicated on the numerical
display )*.
The following applies to TurboSpeed
20 min.:
As soon as ‹:‹‹ is indicated on the
digital display )*, the rinse cycle has
ended. When the appliance door has
been opened, p is indicated on the
digital display. If no further rinse cycle is
required, switch off the appliance with
the ON/OFF switch (.
-/,
Your dishes are being
cleaned.
5/%
Your dishes are being rinsed.
=/<
Your dishes are being dried.
