en
8
As soon as the rinse-aid refill indicator P
is lit on the fascia, there is still a rinse-aid
reserve of 1 – 2 rinsing processes. Refill
with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness is
over 21° dH, rinse aid must be used.
– Open the dispenser 1J by pressing
and lifting the plate on the cover.
– Carefully pour rinse aid up to the max.
mark in the filler opening.
– Close cover until it clicks shut.
– To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with a
cloth.
Setting amount of rinse aid
The amount of rinse aid dispensed can be
set in 4 stages. Accordingly 0, 1, 2 or 3
displays are lit (see water hardness table).
Factory setting: 2.
Do not change the amount of rinse aid
unless streaks (select lower
setting) or water stains (select higher
setting) are left on the utensils.
– Close the door.
– Switch on ON/OFF switch (.
The Cleaning display )" flashes.
– Press and hold down the START
button 8.
– Rotate programme selector 0 until
the rinse aid refill indicator P flashes.
– Release button.
The rinse aid refill indicator P flashes
and the displays h and ` are lit
(= Setting 2).
To change the setting:
– Rotate programme selector 0 until
the required setting has been selected.
– Press START button 8.
The rinse-aid refill indicator P goes
out. The selected setting is saved.
Switching off rinse-aid refill
indicator
If the rinse-aid refill indicator P is
impaired (e.g. when using combined
detergents containing rinse-aid
component), it can be switched off.
– Proceed as described under “Setting
amount of rinse aid” and select
setting 0.
The rinse aid refill indicator P is now
switched off.
Rinse aid %
