en PowerBoost function
14
Once the time has elapsed
The hotplate switches off. A beep sounds and in the
time program function display
‹‹ appears for
10 seconds. The Ú indicator on the hotplate lights up.
Pressing the 0 symbol turns off the indicators and
stops the beeping.
Notes
■ If a cooking time was programmed for several
hotplates, the time information for the selected
hotplate is shown in the timer display.
■ You can set a cooking time of up to 99 minutes.
The kitchen timer
You can use the kitchen timer to set a time of up to 99
minutes.
This functions independently from the hotplates and
from other settings. This function does not automatically
switch off a hotplate.
Setting procedure:
1. The kitchen timer can be set in two different ways:
– If a hotplate has been selected, touch the
0 symbol twice.
– If no hotplate is selected, touch the 0 symbol.
The Ú display beside the U symbol lights up. ‹‹
appears in the timer display.
2. Touch the @ or A symbol. The basic setting
appears.
@ symbol: 10 minutes.
A symbol: 05 minutes.
3. Use the @ or A symbol to set the required time.
After a few seconds, the time begins to elapse.
Changing or deleting the time
Touch the symbol 0 repeatedly until the display Ú
lights up beside the symbol
U. Change the time or use
the symbols
@ or A to set the time to ‹‹.
Once the time has elapsed
A warning signal sounds. ‹‹ is displayed on the time
program function display. After 10 seconds the
indicators turn off.
Pressing the
0 symbol turns off the indicators and
stops the beeping.
vPowerBoost function
Power Boost f unc t i on
The PowerBoost function enables you to heat up large
quantities of water faster than when using heat
setting
Š.
The function can be used by any hotplate provided that
no other hotplates are switched on. Otherwise › and Š
will flash in the heat setting display.
Activation
1. Select a hotplate.
2. Touch the boostG symbol.
› lights up on the display.
The function is activated.
Notes
■ If a hotplate is switched on while the PowerBoost
function is active,
› and Š will flash on the heat
setting display; heat setting Š will then be applied
automatically. The PowerBoost function will now be
deactivated.
■ In the combi zone, the PowerBoost function can only
be activated if the two hotplates are being used
independently of each other.
Deactivation
1. Select the hotplate.
2. Touch the boostG symbol.
› goes out on the display and the hotplate switches
back to the Š heat setting.
The function is deactivated.
Note: In certain circumstances, the PowerBoost
function can switch itself off automatically in order to
protect the electronic elements inside the hob.
from switching on the hob.
The hob should be turned off.
4 seconds. The indicator next to the symbol D lights
up for 10 seconds. The hob is locked.
4 seconds. The lock is now deactivated.
activates when a hob is switched off.
activated.
The hotplate stops heating.
When you touch any symbol, the display switches off.
The hotplate can now be set again.
10 hours).
