en
34
Fault Possible cause Remedial action
Temperature differs
greatly from the set
value.
In some cases it is adequate to
switch off the appliance
for 5 minutes.
If the temperature is too high wait
a few hours and check whether the
temperature has approached the set
value.
If the temperature is too low check
the temperature again the next day.
Displays do not
illuminate.
Power failure; the fuse
has been switched off;
the mains plug has not
been inserted
properly.
Connect mains plug. Check whether
the power is on, check the fuses.
Freezer compartment
door was open
for a long time;
temperature is no
longer reached.
The evaporator
(refrigeration
generator)
in the No Frost system
is covered in thick ice
and can no
longer be defrosted
fully automatically.
To defrost the evaporator, remove
the frozen food with the compart-
ments, insulate well and store in a
cool location.
Switch off the appliance and move
it away from the wall. Leave the
appliance door open.
After approx. 20 min. the condensa-
tion begins to run into the evapora-
tion pan, at the rear of the
appliance. Fig. *
To prevent the evaporation pan from
overflowing in this case, mop up
the condensation with a sponge.
The evaporator is defrosted when
the water stops running into the
evaporation pan. Clean the interior.
Switch the appliance back on again.
