809317
9
Verklein
Vergroot
Pagina terug
1/44
Pagina verder
Installation
9
Compress 3400i AWS – 6721852066 (2023/01)
4.1 Considerations for assembling the indoor unit
Mount the indoor unit at a suitable location within the house. Use a
spirit level to ensure that the appliance is in the correct position.
Make sure that there are no operating ignition sources in the room
where the indoor unit is installed.
Pipe work between the outdoor and indoor units must be as short as
possible. Use insulated pipes.
Check that all pipe connections are intact and have not come loose
during transportation.
Ensure all pipes and connections are protected against physical
damage. Mechanical connections to the indoor unit must be
accessible for maintenance purposes.
Follow the instructions of the outdoor unit installation manual.
Water discharged from the pressure relief valve should be routed
away from the indoor unit to visibly terminate in a frost-free outlet.
The installation location of the indoor unit must have a drain.
The low voltage cables must be routed with a minimum clearance of
100 mm from live 230V cables.
4.2 Heating system minimum volume and flow
A sufficient amount of energy stored in the system is required to avoid
multiple start/stop cycles, incomplete defrosting or unnecessary
alarms. Energy is stored in the heating system water volume, as well as in
the system components (radiators and underfloor heating).
For the defrost operation of the outdoor unit, a minimum volume and
flow must be ensured and permanently available.
The minimum volume can be provided by the open circuits (the
necessary zone valves/thermostats must be always fully open) and/or by
a buffer tank. For an optimal and most efficient defrost operation a
recommended volume is stated.
The minimum flow must be ensured within the minimum volume
available. If the minimum flow is not met, additional measures are
needed, e.g. differential bypass valve or parallel buffer. Note that if an
hydraulic separator is present it requires an additional heating circuit
pump.
In certain circumstances depending on the available energy stored in the
system, the auxiliary heater may be used to ensure the complete defrost.
Table 7 Minimum volume and flow for outdoor unit CS3400iAWS 4 OR-
S
Table 8 Minimum volume and flow for outdoor unit CS3400iAWS 6-10
OR-S
5 Installation
NOTICE
Residue in the pipework can damage the system.
Residue and particles in the heating system impair the flow rate and lead
to faults.
Before connecting the indoor unit, flush the pipe system to remove
any foreign bodies.
CAUTION
Risk of injury!
During transport and installation there is a risk of crushing injury. During
maintenance, internal parts of the appliance may become hot.
The installer is obliged to wear gloves during transport, installation
and maintenance.
The indoor unit is part of a heating system. Faults in the indoor unit can
occur from poor water quality in the radiators or pipework of the
underfloor heating system, or when the oxygen content in the system is
persistently high.
Oxygen causes corrosion products in the form of magnetite and
sediment.
Magnetite is an abrasive material which affects pumps, valves and
components with turbulent flow characteristics, e.g. in the condenser.
If heating systems have to be regularly refilled or if hot water samples
from these systems are cloudy, corresponding measures such as
retrofitting magnetite separators and air vents are required.
Ensure the insides of the pipes are clean and do not contain any
harmful contaminants such as sulphuric compounds, oxidants,
debris and dust.
Never store refrigerant pipes outdoors.
Only remove seals from the pipe ends when you are ready to
connect them.
Utmost care must be taken when routing refrigerant lines.
Only shorten refrigerant lines using pipe cutters and seal the ends
afterwards to prevent the ingress of dirt and moisture.
Dust, foreign bodies and moisture inside the refrigerant lines can be
detrimental to oil quality or can result in compressor failure.
After cutting, immediately reseal reusable lengths of refrigerant
pipes.
Purge the refrigerant pipes with nitrogen.
NOTICE
Danger of malfunction due to contaminants in pipework!
Solids, metal/plastic filings, flux and thread tape residue and similar
material can get stuck in pumps, valves and heat exchangers.
Keep foreign bodies from entering the pipework.
Do not leave pipe parts and connections directly on the ground.
When deburring, make sure that no residue remains in the pipe.
WARNING
Risk of personal injury and damage to property
Using the incorrect sensors may lead to personal injury such as scalding
as well as damage to property due to an excessively high or low
Outdoor Unit CS3400iAWS 4 OR-S
Minimum Recommended
Underfloor/fan coils 13l 35l
Radiators 4l 13l
Minimum flow 15l/min
Outdoor Unit CS3400iAWS 6-10 OR-S
Minimum Recommended
Underfloor/fan coils 27l 40l
Radiators 10l 15l
Minimum flow 15l/min
9

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Bosch-Compress-3400i-AWS

Zoeken resetten

  • bosch compress hybrid 3400i AW geeft deze storing aan A11/3071 geen communicatie met afstandsbediening, neem contact op met uw installateur. Kan ik dit zelf oplossen of moet ik idd een installateur raadplegen? Gesteld op 2-12-2024 om 22:51

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bosch Compress 3400i AWS bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bosch Compress 3400i AWS in de taal/talen: Engels als bijlage per email.

De handleiding is 7.89 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Bosch Compress 3400i AWS

Bosch Compress 3400i AWS Gebruiksaanwijzing - English - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info