Touch panel lock
To activate this function, press the “key” button for
at least 2 seconds. All burner power levels will re-
main in their current status. When the touch panel
is locked the decimal points light up in the display of
each burner. When the touch panel is locked, it is not
possible to change the burner power levels or change
the timer settings, but it is possible to switch the hob
off by pressing the ON/OFF button. Locked burners cannot be reset when the touch panel lock is
activated. The touch panel must be unlocked before performing the burner reset procedure.
Touch panel unlock
To unlock the touch panel, press the “key” button and the “+” button of the LH burner for at least
2 seconds. When the touch panel is unlocked the decimal points switch off in the power level
displays.
Programming burner off time
Each burner can be programmed to operate for a speci-
fied time, after which it switches off automatically.
To program the timer of a specific burner, press the
“timer” button. The position of each burner is shown
by means of a LED on the control panel. The LED will
illuminate to indicate that the burner has been selected
for programming. Select the burner with which to associate the timer using the “+” and “-” but-
tons. The timer display will show 00.00, meaning that the timer of the selected burner is not
activated.
Press the “key” button again. The flashing digits on the left of the dot indicate the hour and the
digits on the right indicate the minutes. Increase or decrease cooking time from 0 to 9 hours
using the “+” and “-” buttons. Hold down the “+” or “-” button to increase or decrease the hours
digits rapidly. To set the minutes, press the “key” button again. The digits on the right of the dot
start flashing. Set the minutes as described above for the hours.
When programming the cooking time you can cancel the current setting at any time by pressing
the “+” and “-” buttons simultaneously.
If the time is set to zero, the timer is deactivated. To confirm the time displayed, press the “key”
button.
At this point the indicators exclusively of the burners with active timer will continue flashing. Press
the “timer” button to access programming mode and display the time remaining before the burner
