651963
27
Verklein
Vergroot
Pagina terug
1/46
Pagina verder
27
HL1120CB_ IM 07.04.16
Overview of the Components
1 Handle
2 Function control knob
2a
= Off
2b
= Fan
2c
= 1000 Watt
2d
= 2000 Watt
3 Function indicator lamp
4 Temperature control
5 Knurled screws
6 Stand
7 Protective grille
Notes on use
Unpacking the appliance
1. Remove the appliance from its packaging.
2. Remove all packaging material such as foils, padding,
cable holders and cardboard.
3. Fully unwind the cable.
NOTE:
There might be dust and production residue present on the
appliance. We recommend cleaning the device as described
under “Cleaning”.
Position
CAUTION:
The appliance may tip over onto its front, blocking the air
ow.
Always set the appliance onto the stand. The ideal position is a
non-slip, at surface.
Electric connection
1. Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
2. Set the control knob to
.
3. Connect the mains plug to a properly installed isolated
ground socket.
Connected load
The appliance supports a power input of 2000 W.
CAUTION: Overload:
When using an extension cord, it must have a cable
cross-section of at least 1.5 mm².
Do not use multi-outlet power strips, since this appliance
is too powerful.
Do not connect any other powerful devices to the same
electric circuit.
Operation
Setting the temperature
The thermostat constantly switches the radiator on and off,
thereby keeping the temperature at the desired level. Set the
desired temperature as followed:
1. Set the temperature control to its highest setting.
2. Once the desired temperature has been reached, slowly
turn the temperature control back, until the radiator switch-
es off audibly. The indicator lamp turns off.
NOTE:
The audible position of the temperature control depends
on the ambient temperature.
3. The radiator will then keep the desired temperature level.
CAUTION:
When not using the appliance, disconnect the mains plug.
Adjusting the inclination angle
Do you want to change the inclination angle?
Proceed as follows:
1. Loosen the knurled screws slightly by turning them counter-
clockwise, so that you can move the housing.
NOTE:
Only loosen the knurled screws. Otherwise the housing
will fall off the stand.
2. Swivel the housing to the desired position.
3. Fix the housing by tightening the knurled screws again.
The radiator should not be placed directly below a mains power
socket.
Do not try to repair the appliance on your own. Always contact an
authorized technician. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent or similarly qualied
persons in order to avoid a hazard.
27

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bomann HL 1120 CB bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bomann HL 1120 CB in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans, Pools als bijlage per email.

De handleiding is 3,41 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info