50
☞
Slide the hole cover (L) off the ventilation grille and fit it on the
opposite side.
Pannelling the door
☞
Take off the door frame section opposite to the door handle;
☞
loosen, without removing them, all remaining screws securing the door
frame;
☞
slide in the decor panel from the frameless side, then fasten again the
frame to the door including the previously removed frame section.
Note:
The overall dimensions of the decor panel must be 1 to 2 mm less than
those of the door, with a maximum thickness of 4 mm.
Prior to Initial Start–Up
Please clean the appliance interior and all accessories prior to initial start-up (see section: “Cleaning and
Care”).
Plug socket
The plug socket necessary for con-nection of your appliance to the electricity supply should be positio-
ned so that it is possible to pull out the appliance plug.
If your appliance is installed under a continuous worktop, the plug socket should be provided as shown.
A concealed protective contact plug socket requires 10 A/16 A fusing.
If the socket is not accessible once the appliance is built in, the electrical installation must include suita-
ble means of isolating the appliance from the mains (e.g. fuse, cut-out, current trip or similar with a
minimum contact separation of 3 mm).
☞
Before initial start-up, refer to the appliance serial plate to ascertain if supply voltage and current values
correspond with those of the mains at the installation location.
e.g.: AC 220 ... 240 V 50 Hz or
220 ... 240 V ~50 Hz
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
☞
