Handleiding Blaupunkt tha 475 pnp (pagina 7 van 52) (Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools, Turks, Deens, Zweeds, Fins)

166907

Verklein

Vergroot

Pagina terug

1/52

Pagina verder

THA 475 PnP

Note:

If the connection is made using a PnP-INPUT cable,

the switch-on is performed automatically.

! As a special feature, +12 V/200 mA are now available

as output switching voltage at the remote input/out-

put after automatic switch-on.

High-level connections (via PnP High-

Inputcable only)

The ampliﬁ er features high-level connections (High

Input) to be able to connect to radio devices without pre-

stage outputs (Fig. 2). This allows for a direct connection

at the loudspeaker output of the radio device.

Note:

Unused Out/Input connectors from the PnP cable must

be connected (see Fig. 2a *).

Direct Aux Input connection

Connection option in case of missing or occupied

AUX input at the car sound system

Various NF sources, such as an MP3 player or

a mobile navigation, can be directly connected

via a 3.5-mm jack plug at the Direct Aux Input.

All signal sources can be listened to at the same

time and their volume is adjusted at the respec-

tive source device.

Note:

All NF sources must be switched off during in-

stallation and connection!

Installing the jack plug cable

Please use our 5-m jack plug cable with order

number 7 607 001 525 for the connection.

One of its special features is an on/off switch.

Switch position OFF (•):

For installation and deinstallation and no con-

nected NF source.

Switch setting ON: (I / II):

Only after an NF source has been connected.

Caution:

For the connection, always adjust the volume

control to minimum and switch off the ampliﬁ er.

If you want to listen to one sound source via

the front and rear loudspeakers, you must con-

nect the Direct Aux inputs with our Y jack plug

cable (7 607 001 524), (see Fig. 6).

Level control

The Level control is used to adjust the input sensitivity

of the power ampliﬁ er to the output voltage of your car

sound system.

The adjustment range is from 0.3 V to 8 V.

A few important explanations in this context:

By turning the control clockwise, the input sensitivity of

the ampliﬁ er and, therefore, also the volume increases.

However, this is not a volume control; no further ampli-

ﬁ er output can be achieved in the end position, even if it

may sound like that at the beginning. The system merely

increases the volume faster if the volume control of the

car sound system is turned up.

Loudspeaker connections

(If the ampliﬁ er is to be jumpered, continue with the sec-

tion "Bridged loudspeaker connections" at this point).

As with every audio component, the correct polarisa-

tion of ampliﬁ er and loudspeakers is of essentially

importance for a good bass response. For this reason,

ensure that the positive (+) connection of the ampliﬁ er

is connected with the positive connection (+) of the

loudspeaker; the same applies to the negative (-) con-

nections. In addition, the left ampliﬁ er channel must

be connected with the left loudspeaker and the right

ampliﬁ er channel with the right loudspeaker.

Bridged loudspeaker connections

Note: Not possible for connection via PnP cable.

The THA 475 PnP ampliﬁ er allows for switching the

channels 1+2 and 3+4 as bridge connection. This allows

the ampliﬁ er to be used for one or several subwoofers

or a mid-range driver. In this conﬁ guration, the ampliﬁ er

combines the right and left channel to a single-channel

output (mono output).

Note:

The ampliﬁ er can add the right and left signal informa-

tion only if the right as well as the left RCA connection

were carried out.

Caution:

In a bridge circuit, the ampliﬁ er load must be 4 ohm

or higher. A lower load leads to an overheating or

switch-off of the ampliﬁ er and can cause permanent

damages.

Adjusting the type and range of the frequency

crossovers

With the THA 475 PnP, the type of frequency crossover

(i.e. "Low Pass" or "Hi-Pass") and the desired crossover

frequency can be adjusted. For example, if a pair of

subwoofers is to be connected, low-pass settings are

required. The crossover frequency is dependent upon

the frequency range of the loudspeakers (see recom-

mended frequency range of the loudspeakers).

High-Pass

At a setting of 250 Hz, the ampliﬁ er has a frequency

range of 250 Hz to 30,000 Hz.

Low-pass frequency control

This control is active if the switch is in the position

"Low-Pass", and allows for setting the desired crossover

frequency.

Example:

At a setting of 150 Hz, the ampliﬁ er has a frequency

range of 10 Hz to 150 Hz.

THA_475_PnP_0507.indd 7THA_475_PnP_0507.indd 7 30.05.2007 12:06:34 Uhr30.05.2007 12:06:34 Uhr

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Blaupunkt tha 475 pnp Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info