23. Never hold the cutter head above foot height or point it towards people or animals when in use.
24. If the trimmer starts to vibrate excessively. Switch off immediately and have it checked by a qualified service engineer.
25. Caution: the cutting head continues to rotate for a few seconds after switching off.
26. Always remove any sticks and stones etc. before using the trimmer.
27. Never run while using the trimmer.
28. Do not cross roads or gravel paths while operating trimmer.
29. On steep slopes cut across the slope, never in an up and down direction.
30. Never fit a metal replacement line.
31. Never use the trimmer while it is raining or in damp weather.
32. Use the trimmer in daylight or good artificial light. Never use when visibility is bad.
33. Do not overreach, keep proper footing and balance at all times.
DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY,
Do not use the lawn trimmer (edge trimmer), if the cords are damaged or worn.
Wear stout shoes or boots to protect your feet. Wear long trousers to protect your legs.
Before using the tool, check that your cutting path is free from sticks, stones, wire and any other obstacles.
Only use the tool in the upright position, with the cutting line near the ground. Never switch the tool on in any other position.
Move slowly when using the tool. Be aware that freshly cut grass is damp and slippery.
Do not work on steep slopes. Work across the face of slopes, not up and down.
Never cross gravel paths or roads while the tool is running. Never touch the cutting line while the tool is running.
Do not put the tool down until the cutting line has come to a complete standstill.
Use only the appropriate type of cutting line. Never use metal cutting line or fishing line.
Be careful not to touch the line trimming blade.
Take care to keep the mains cable away from the cutting line. Always be aware of the position of the cable.
Keep hands and feet away from the cutting means at all times and especially when switching on the motor.
Warning. Cutting wire continue to rotate after the motor is switched off. Never operate the machine with damaged guards or
without the guards in place.
Always ensure that the ventilation openings are kept clear of debris. Be familiar with the controls and the proper use of the
equipment. Only use the machine in daylight or good artificial light.
Before use check the supply and extension cord for any signs of damage or aging. If the cord becomes damaged during use,
disconnect the cord from the supply immediately.
