Madeira RCR 85 gb
24
Reception of traffic announcements with RDS-EON
If you press TA when a traffic announcement
is played, the radio stops playing the messa-
ge and switches to the previous mode. The
priority of later traffic announcements re-
mains on.
Warning beep
Whenever you leave the reception area of
the traffic program station you are tuned to,
you will hear a warning beep after approxi-
mately 30 seconds.
This warning beep will also be released, if
you press a preset button on which a station
without traffic program is stored.
Switching the warning beep off
a) Tune to another traffic program station:
• Press the rocker switch or
• press a preset button to recall a
traffic program station.
or
b) Switch the traffic message priority off:
• Press TA.
“TA” goes out in the display.
Sampling stations briefly
with Radio Scan
This function allows you to sample all sta-
tions for approximately 8 seconds each.
To activate Scan:
• press knob 1 for approximately 1 sec-
ond.
Then sampled frequency or the station
name starts flashing in the display. Dur-
ing the actual searching process,
“SCAN” is flashing.
To continue listening to a sampled stati-
on/switch Preset Scan off:
• briefly press knob 1.
If no station is selected during the search
operation, the scan function will be automa-
tically switched off after the entire frequency
band has been passed through. The radio
will then return to the initial station that was
being played when the scan function was
activated.
Many FM broadcasters provide their service
area with traffic messages at regular inter-
vals.
All traffic program stations transmit a special
signal parallel to the radio program. Your car
radio is able to identify such traffic program
station by this TP signal. The display will
indicate “TP” to confirm that a traffic program
station is tuned in.
Other radio stations do not air traffic announ-
cements by themselves, but offer the possi-
bility to receive the traffic announcements of
another radio station within the same radio
network. During reception of such a station
(e.g. NDR3) “TP” lights on the display as
soon as the priority of traffic announcements
is activated. Then the display has to light
“TA”.
If a traffic announcement is aired, your radio
will switch to the traffic program station for the
duration of the message and will switch back
to the previous station after the end of the
message.
Priority of traffic announcements
ON/OFF
“TA” lights up in the display, if the priority of
traffic announcements is on. To switch the
function on and off,
• press the TA button.
