581267
6
Verklein
Vergroot
Pagina terug
1/88
Pagina verder
6
ENGLISH
X Plug in the charger (8) and switch on at the mains.
X Insert the battery pack (7) into the charger. Make sure
that the battery pack is fully seated in the charger (8).
X The charging indicator (9) will flash continuously
(slowly).
X Leave the battery to charge for at least 5 to 6 hours.
X The charge is complete when the charging indicator (9)
lights continuously
X The charger and the battery pack can be left connected
indefinitely with the LED illuminated. The LED will
change to flashing (charging) state, as the charger
occasionally “tops off“ the battery charge.
X The charging indicator (9) will be lit as long as the
battery pack is connected to the plugged-in charger.
X Charge discharged batteries within 1 week. Battery life
will be greatly diminished if stored in a discharged state.
Charge indicators
If the charger detects a problem with a battery pack, the
charge indicator (9) will flash at a fast rate.
X If this occurs, re-insert the battery pack (7).
X If the problem persists, put a different battery pack in the
charger to determine if the charger is OK.
X If the new pack charges correctly, then the original pack
is defective and should be returned to a service centre
for recycling.
X If the new battery pack gives the same indication as the
original, take the charger to be tested at an authorized
service centre.
Note: It may take as long as fifteen minutes to determine that
the pack is defective.
If the battery pack is too hot or too cold, the LED will
alternately blink fast and slow, one flash at each speed and
repeat.
Daisy chain (fig. C)
Black & Decker single and dual port VPX battery chargers
can be electrically connected in any order up to a maximum
of 4 chargers. Each charger has a power-in cord (10) which
plugs into the electrical outlet and a power-out cord (11)
which plugs into the next charger.
To connect chargers in a daisy chain:
X Plug the power-in cord (10) into an electrical outlet.
X Remove the power-in cord from the next charger and
plug in the power-out cord (11) from the charger that is
now plugged into the outlet.
X Repeat this process for the remaining chargers.
Chargers that are daisy chained together operate
independently as though each one was plugged into a
separate outlet, therefore a battery can be removed from
anywhere along the daisy chain without affecting the other
chargers.
Use
Switching on and off (fig. D)
The tool is equipped with a switch lock-off feature to prevent
unintentional operation.
X To operate the tool, slide the switch lock-off button (1) to
the back and hold it as you pull the on/off trigger
switch (2).
X When the tool is running, release the switch lock-off
button (1). The tool will continue to run while the on/off
trigger switch (2) is pressed.
X To turn the tool off, release the on/off trigger switch (2).
There is no provision for locking the tool in the on
position.
X Hold the saw firmly with one or both hands while cutting.
Whenever possible, the saw shoe must be held firmly
against the material being cut. This will prevent the saw
from jumping or vibrating and minimize blade breakage.
Fitting the saw blade (fig. E)
Your saw accepts both T-shank and universal shank jig saw
blades. 1 mm or thicker blade recommended.
Warning! Recently used blades may be hot.
X Hold the saw blade (5) securely. If the saw blade is fitted
with a tooth protector, leave it attached while fitting the
blade.
X Push down on the blade clamp release lever (3) to
release the blade clamping mechanism.
X Insert the shank of the saw blade (5) into the blade
holder as far as it will go.
X Release the blade clamp lever (3) to lock the blade
clamping mechanism.
X Remove the tooth protector, if fitted.
To remove a blade from the saw:
X Push down on the blade clamp release lever (3) to its full
open position.
X Remove the blade (5).
X Release the blade clamp release lever (3).
Sawing
X Let the blade run freely for a few seconds before starting
the cut.
X Apply only a gentle pressure to the tool while performing
the cut.
X If possible, work with the shoe (4) pressed against the
workpiece. This will improve tool control and reduce tool
6

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Black Decker VPX1301 T1 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Black Decker VPX1301 T1 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Deens, Zweeds, Noors, Fins als bijlage per email.

De handleiding is 1,12 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Black Decker VPX1301 T1

Black Decker VPX1301 T1 Snelstart handleiding - English - 12 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info