578632
11
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
11
ENGLISH
(Original instructions)
u Maintain smooth and consistent speed which will help
avoid inconsistencies. Begin spraying after the pass has
begun and release trigger before stopping the pass.
u Avoid spraying too heavily in any one area. Several lighter
coats are better than one heavy coat which can lead to
running and dripping. Remember that the ow control
knob regulates the amount of liquid that can be sprayed.
Turning the ow knob clockwise increases the ow of
liquid. Turning the knob counterclockwise decreases the
ow of liquid. If runs or drips do occur, have a dry paint
brush on hand to smooth them out.
u Turn the power unit off and place the sprayer in the built-in
dock of the power unit when not spraying for any length of
time.
Maintenance and cleaning
Your Black & Decker corded appliance has been designed to
operate over a long period of time with a minimum of main-
tenance. Continuous satisfactory operation depends upon
proper appliance care and regular cleaning.
Warning! Be sure to use appropriate personal protective
equipment.
Warning! Before performing any maintenance or cleaning on
corded appliances switch off and unplug the appliance.
Warning! Do not use materials with a ashpoint lower than
55°C. Flashpoint is the temperature that a uid can produce
enough vapours to ignite (see paint supplier instructions).
Warning! Make sure clean up area is well ventilated and free
of ammable vapours.
Warning! Always spray outdoors when spraying cleaning
solution through sprayer.
Warning! Do not submerse power unit.
Flushing the sprayer (g. N)
u Disconnect the sprayer from the power supply.
u Unscrew the lid from the side of the canister and pour any
remaining liquid back into the original container (g. N).
u Pour a small amount of the appropriate cleaning solution
into the canister.
t Warm soapy water for water based materials.
t Manufacturers recommended cleaning solution for oil
based materials.
u Replace the lid on the canister securely and vigorously
shake the sprayer.
u Unscrew the lid from the side of the canister and properly
dispose of cleaning solution.
u Rell the canister with a small amount of new cleaning
solution. Screw lid securely on canister.
u Reattach the sprayer to the motor unit, plug in the cord
and turn on the power unit.
u Spray the cleaning solution through the sprayer onto scrap
material for 2 to 3 seconds.
Cleaning the sprayer (g. O - S)
u Disconnect the sprayer from the power supply.
u Remove the side ll canister (6) and unscrew the side
lid (7). Remove the check valve (18), pickup tube (15)
and o-ring (17) from the sprayer. Clean the parts in the
appropriate cleaning solution (g. O).
u Unscrew the tip collar (19) and remove the spray nozzle
(10) and spray tip (20). Clean all parts in the appropriate
cleaning solution (g. P).
u If using water based material, clean the sprayer by running
water through pickup tube inlet. If using oil based materi-
als, clean pickup tube inlet with the appropriate cleaning
solution. Repeat until sprayer is completely clean. Take
special care to gently clean the spraying needle (21).
u Dry all parts thoroughly.
u Properly dispose of cleaning solution.
u Place a drop of household oil onto the metal ball in the
check valve (18) (g. Q).
Important : Lubricating the ball in check valve (18), after
cleanup, will help to prevent it from sticking which can clog the
valve and prevent adequate ow of spray material.
Note : When reassembling, place metal ball end of check
valve (18) into sprayer.
u Reassemble sprayer (g. S).
Note : The spray tip (20) can only go in one way. The notch
(22) on the spray tip must align with the recess in the threads
of the sprayer (g. R).
Cleaning the power unit
u Disconnect the sprayer from the power supply.
u Use only mild soap and damp cloth to clean the power
unit.
Warning! Never let any liquid get inside the power unit.
Warning! Never immerse any part of the power unit into a
liquid.
Cleaning the lter
The power unit contains a washable/reusable lter (g. T).
Check the lter before and after each use. If dirty, wash with
warm water and allow to air dry before re-installing or replace
if necessary.
u To check the lter, remove the lter cover (11) by removing
the 2 screws from the top of the lter cover then pulling
the cover off the power unit.
u Remove the lter (23) and inspect.
u Replace the lter and lter cover.
Warning! Never operate the power unit without the lter in
place. Debris could be sucked in and interfere with the func-
tion of the power unit.
11

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Black Decker HVLP200 T1 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Black Decker HVLP200 T1 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,87 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Black Decker HVLP200 T1

Black Decker HVLP200 T1 Gebruiksaanwijzing - Nederlands, Deutsch, English, Français, Italiano, Português, Espanõl, Dansk, Svenska, Norsk, Suomi - 112 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info