Handleiding Black Decker GR360 T1 (pagina 5 van 60) (Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Spaans)

586086

Verklein

Vergroot

Pagina terug

1/60

Pagina verder

ENGLISH

By moving the 5 position height of cut

adjuster (34) at the rear of your mower

outwards from your mower body (1) and

then up or down as required, the height of

cut can be varied to give 5 positions.

Note: The 5 position height of cut adjuster is

under tension when in the engaged position.

It has to be sprung outwards to move from

one height setting to another and will spring

back automatically into position when released.

The maximum to medium height of cut

settings, as indicated by arrows 1, 2 and 3

are suitable for coarse or overgrown grass.

Settings 4 and 5 should be used for

maintaining cultivated lawns.

Grassbag assembly (Fig. E)

Read the safety instructions at the beginning

of this manual before using this accessory.

• Before starting to assemble the

grassbag, check that the parts are similar

to those shown in Fig. E1.

• Secure the grassbag by inserting the bag

rim into the channel and pushing down

firmly until the clip feature locks onto the

bag rim (inset).

• Push the support frame firmly into place.

• Assemble the two side clips to the

support frame, then assemble the

bottom clip.

Fitting the grassbag to your mower:

• Hold the grassbag top (26) by its handle.

• Lift the grassflap (7), then guide the

grassbag through the lower handle tube

(10) and fix to the rear of the unit by lining

up the arrows marked on the cutter deck

(2) and grassbag top (26).

• Finally, when this is complete, gently

release the grassflap (7) and it will return

to sit onto the location area of the

grassbag top (26).

How to use your mower (Fig. H & J)

Observe all the relevant warnings when

using your mower.

We recommend the directional method of

operation as shown in Fig. H to obtain the

maximum cutting performance from your

mower and to reduce the risk of the trailing

extension lead from entering the cutting path.

• Place the bulk of the extension cable on

the lawn close to the starting point

(Fig. Ha, position 1).

• Hold the handle assembly with both

hands.

Your switch box incorporates a cable

restraint. To fix the cable to the restraint,

proceed as follows:

• Bring the socket end of the extension

cable from behind and connect it to your

mower plug.

• Form a loop on your extension cable

close to the coupler.

• Push the loop through the slot from the

opposite side of the restraint hook,

position the loop over the hook and pull

the cable back through the slot. Your

cable will now be restrained.

• The extension cable should now fall

away from your mower and behind the

operator, ready for use.

Warning! Do not attempt to operate your

mower with one hand - you must guide it

with both hands.

• Tilt the unit backwards to reduce the risk

of lawn damage whilst starting, depress

the safety lock-off button (20) on the

switchbox (24) (Fig. A), and whilst still

depressed pull the switch lever (21)

towards you. Your mower will start, and

you can now allow your mower to return

to its proper cutting position, and

commence cutting.

• Proceed down the cutting area as shown

in Fig. Ha, working from position 1

towards position 2 and, on reaching

position 2, turn to the right and proceed

towards position 3. Continue to the end

of the cutting area, turn to the left, and

proceed towards position 4. Continue in

the same manner as shown in Fig. Ha,

always working away from the cable.

Do not adopt the method shown in Fig.

Hb, working towards the cable, as this

can be dangerous.

Your mower will continue to operate whilst

you are depressing the switch lever. To stop

your mower release the switch lever.

When you have finished using your mower

we recommend that you clean all debris from

it before putting it away. Refer to the “Care

and maintanence” section.

Note: To obtain the best results cut your

lawn or grassed area regularly and do not

cut when the grass is wet.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Black Decker GR360 T1 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van Black Decker GR360 T1

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info