586103
14
Verklein
Vergroot
Pagina terug
1/164
Pagina verder
14
ENGLISH
(Original instructions)
Your charger does not require any maintenance apart from
regular cleaning.
Warning! Before performing any maintenance on corded/
cordless power tools:
u Switch off and unplug the appliance/tool.
u Or switch off and remove the battery from the appliance/
tool if the appliance/tool has a separate battery pack.
u Or run the battery down completely if it is integral and then
switch off.
u Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
u Regularly clean the ventilation slots in your tool/appliance
and charger using a soft brush or dry cloth.
u Regularly clean the motor housing using a damp cloth. Do
not use any abrasive or solvent-based cleaner.
u Regularly use a blunt scraper to remove grass and dirt
from the underneath of the guard.
Removing and installing the blade (g. S, T & U)
Warning! Do not touch the blade before the safety key has
been removed and the blades have come to a complete stop.
u Release the bail bar (2) to turn mower off, wait for the
blade to stop and remove the safety key (1).
u Cut a piece of wood (approximately 50 mm x 100 mm x
600 mm long) to use to keep the blade from turning while
removing the ange nut (29).
u Turn the mower on its side.
Warning! Wear gloves and proper eye protection. Be careful
of the sharp edges of the blade.
u Position the wood (28) and remove the ange nut (29)
with a 13 mm wrench (g. S).
u Remove the washer (30), blade (31), square blade guide
(32) and the fan (33) (g T). Examine the blade guide (32)
and fan (33) for damage and replace if necessary.
When tting the blade, make sure that the grass side of the
blade (Indicated by arrows on either end) will face the ground
when the mower is returned to its normal upright position.
u Install the fan (33). Be sure to position the fan blades (34)
so that they face in towards the mower.
u Install the blade guide (32). Be sure to position the 'D'
shaped pegs (35) so that they face out, away from the
mower.
u Be sure to align the ats on the on the fan (33) and the
blade guide (32) with the ats of the shaft.
u Fit the blade (31) onto the blade guide (32) with the ar-
rows facing outwards.
u Position the piece of wood (28) to keep the blade (31)
from turning (g. U).
u Install the washer (30) and ange nut (29) then tighten
with a 13mm wrench.
Blade sharpening (g. V)
Keep the blade sharp for best performance. A dull blade does
not cut grass cleanly or mulch properly.
Warning! Always make sure that the safety key is removed.
Warning! Wear proper eye protection while removing, sharp-
ening and installing a blade.
Sharpening the blade twice during a mowing season is usually
sufcient under normal circumstances. Sand causes the
blade to dull quickly. If your lawn has sandy soil more frequent
sharpening may be required.
u Replace bent or damaged blades immediately.
When sharpening the blade:
u Make sure that the blade remains balanced.
u Sharpen the blade at the original cutting angle.
u Sharpen the cutting edges on both ends of the blade,
removing equal amounts of material from both ends.
To sharpen a blade in a vice (g. V)
u Release the bail bar (2) to turn the lawnmower off and wait
for the blade to come to a complete stop.
u Remove the safety key (1) and the battery pack (22) and
turn the lawnmower on to its side.
u Remove the blade (31) from the mower, see the instruc-
tions for removing and installing blades.
Warning! Wear proper eye protection and gloves and be
careful of the sharp edges of the blade.
u Put the blade (31) in a vice.
u Carefully le the cutting edges of the blade with a ne
tooth le or a sharpening stone, maintaining the original
cutting edge.
u Check the balance of the blade, see the instructions for
blade balancing.
u Install the blade (31) on the mower and tighten securely,
see the instructions for removing and installing blades.
Blade balancing (g. W)
u Check the balance of the blade by putting the centre hole
in the blade on to a nail or a round shank screwdriver that
is clamped horizontally in a vice. If either end of the blade
rotates downward, le that end of the blade until the blade
is balanced.
Lubrication
No lubrication is necessary. Do not oil the wheels. They have
plastic bearing surfaces which require no lubrication.
Cleaning
u Release the bail bar (2) to turn the lawnmower off and wait
for the blade to come to a complete stop.
u Remove the safety key (1).
u Use only mild soap and a damp cloth to clean the mower.
u Use a blunt tool to clean out any clippings which may have
accumulated on the underside of the mower.
u After several uses, check all exposed fasteners for tight-
ness.
Preventing corrosion
Fertilisers and other garden chemicals contain agents which
greatly accelerate the corrosion of metals. If you mow in areas
where fertilisers or chemicals have been used, the mower
should be cleaned immediately afterward as follows:
u Release the bail bar (2) to turn the lawnmower off and wait
for the blade to come to a complete stop.
14

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Black-Decker-CLM3820-T1

Zoeken resetten

  • grasmaaier start na het plaatsen van de batterij en de veiligheidssleutel niet onmiddellijjk, na een week stilstand Gesteld op 27-5-2020 om 10:28

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Black Decker CLM3820 T1 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Black Decker CLM3820 T1 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Deens, Zweeds, Noors, Fins als bijlage per email.

De handleiding is 8,68 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Black Decker CLM3820 T1

Black Decker CLM3820 T1 Snelstart handleiding - English - 20 pagina's

Black Decker CLM3820 T1 Gebruiksaanwijzing - Polski - 24 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info