- EN 6 -
4. Use the “SKIP+ / TUNING+” & “SKIP- / TUNING-” buttons to set the hours accordingly. The hour
digits start ashing.
5. Press the “CLOCK / FM ST.” button to conrm the hour.
6. The minute digits start ashing. Use the “SKIP+ / TUNING+” & “SKIP- / TUNING-” buttons to set
the minute accordingly.
7. Use the “SKIP+ / TUNING+” & “SKIP- / TUNING-” buttons to set the minute accordingly.
8. Press the “CLOCK / FM ST.” button to conrm the minute.
NOTE:
• The clock time settings will be erased in the event of power interruptions.
• Press and hold the “CLOCK / FM ST.” button during operation order to briey display the current
time.
Volume
• You can set the desired volume with the “VOLUME+” & “VOLUME-” buttons.
Listening to the Radio
1. Select the RADIO mode with the “STANDBY / FUNCTION” button.
2. For FM reception: Completely extend the telescopic antenna. Change its position to improve the
reception.
3. There are two options to search for and preset radio stations.
Automatic scan:
Important! Any preset radio stations will be overridden.
• Press and hold the “AMS / MODE” button for approx.3 seconds. The system scans the entire
frequency band for radio stations. Any stations found will be preset from lowest to highest frequency.
Manual scan for audio stations:
• Briey press the “SKIP+ / TUNING+” & “SKIP- / TUNING-” buttons, until you have found the radio
station which you are looking for. If you keep one of the buttons pressed down, the device will search
to the previous, respectively next radio station.
Preset station:
1. Press and hold the “AMS / MODE” button on unit for about 2-3 seconds to start the automatic
preset process.
2. Display will show the memory sequence number and radio stations will be automatically preset
into the sequence number (Note: Each sequence number means 1 preset station while during
automatic preset process.)
3. Once all the stations were automatic preset, press the “PRE.+ / FOLDER+” or “PRE.- / FOLDER- “
buttons to choose preset stations.
Playing CDs/MP3
1. Select the CD mode with the “STANDBY / FUNCTION” button.
2. Open the CD compartment by pulling the lid upwards by the tab.
3. Insert an audio CD with the printed side facing upwards on to the central cone so that the CD clicks
into place and then close the lid of the CD compartment.
4. After a few seconds the total number of songs/tracks is shown in the display.
NOTE:
• In the case of CDs in MP3 format the number of folders is briey displayed at rst.
5. The CD will play from the rst title.
6. In order to remove a CD, please press the STOP button, open the CD compartment and lift the CD
out carefully. Always keep the CD deck closed.
