Handleiding Beurer IH 50 (pagina 77 van 80) (Duits, Engels, Frans, Italiaans, Spaans, Pools, Turks)

568805

Verklein

Vergroot

Pagina terug

1/80

Pagina verder

Electromagnetic Compatibility Information

Table 1

For all ME EQUIPMENT and ME SYSTEMS

Guidance and manufacturer’s declaration – electromagnetic emissions

The IH 50 is intended for use in the electromagnetic environment speciﬁed below.

The customer or the user of the IH 50 should assure that it is used in such an environment.

Emissions Compliance Electromagnetic environment – guidance

RF emissions CISPR 11 Group 1 The IH 50 uses RF energy only for its internal function. Therefore, its RF emissi-

ons are very low and are not likely to cause any interference in nearby electronic

equipment.

RF emissions CISPR 11 Class B The IH 50 is suitable for use in all establishments, including domestic establish-

ments and those directly connected to the public low-voltage power supply net-

work that supplies buildings used for domestic purposes.

Harmonic emissions IEC 61000-3-2 Class C

Voltage ﬂuctuations/ﬂicker emissions

IEC 61000-3-3

Complies

Table 2

For all ME EQUIPMENT and ME SYSTEMS

Guidance and manufacturer’s declaration – electromagnetic immunity

The IH 50 is intended for use in the electromagnetic environment speciﬁed below.

The customer or the user of the IH 50 should assure that it is used in such an environment.

Immunity test EN 60601 test level Compliance level Electromagnetic environment – guidance

Electrostatic discharge (ESD)

IEC 61000-4-2

± 6 kV contact

± 8 kV air

± 6 kV contact

± 8 kV air

Floors should be wood, concrete or cera-

mic tile. If ﬂoors are covered with synthetic

material, the relative humidity should be at

least 30 %.

Electrical fast transient/burst

IEC 61000-4-4

± 2 kV for power supply lines ± 2 kV for power supply lines

Mains power quality should be that of a typi-

cal commercial or hospital environment.

Surge

IEC 61000-4-5

± 1 kV line(s) and neutral ± 1 kV line(s) and neutral

Mains power quality should be that of a typi-

cal commercial or hospital environment.

Voltage dips, short interrup-

tions and voltage variations

on power supply input lines

IEC 61000-4-11

<5 % U

(>95 % dip in U

)

for 0.5 cycle

40 % U

(60 % dip in U

)

for 5 cycles

70 % U

(30 % dip in U

)

for 25 cycles

<5 % U

(>95 % dip in U

)

for 5 s

<5 % U

(>95 % dip in U

)

for 0.5 cycle

40 % U

(60 % dip in U

)

for 5 cycles

70 % U

(30 % dip in U

)

for 25 cycles

<5 % U

(>95 % dip in U

)

for 5 s

Mains power quality should be that of a typi-

cal commercial or hospital environment.

If the user of the IH 50 requires continued

operation during power mains interruptions,

it is recommended that the IH 50 be powe-

red from an uninterruptible power supply or

a battery.

Power frequency

(50/60 Hz)

magnetic ﬁeld

IEC 61000-4-8

3 A/m Not applicable Not applicable

NOTE: U

is the a.c. mains voltage prior to application of the test level.

Table 3

For ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING

Guidance and manufacturer’s declaration – electromagnetic immunity

The IH 50 is intended for use in the electromagnetic environment speciﬁed below.

The customer or the user of the IH 50 should assure that it is used in such an environment.

Immunity test IEC 60601

test level

Compliance

level

Electromagnetic environment – guidance

Conducted RF

IEC 61000-4-6

Radiated RF

IEC 61000-4-3

3 V

rms

150 kHz to

80 MHz

3 V/m

80 MHz to

2,5 GHz

3 V

rms

3 V/m

Portable and mobile RF communications equipment should be used no closer to any part

of the IH 50, including cables, than the recommended separation distance calculated from

the equation applicable to the frequency of the transmitter.

Recommended separation distance:

d = 1,2

d = 1,2 80 MHz to 800 MHz

d = 2,3

800 MHz to 2,5 GHz

Where P is the maximum output power rating of the transmitter in watts (W) according to the

transmitter manufacturer and d is the recommended separation distance in metres (m).

Field strengths from ﬁxed RF transmitters, as determined by an electromagnetic site survey,

should be less than the compliance level in each frequency range.

Interference may occur in the vicinity of equipment marked with the following symbol:

NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.

NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is aected by absorption and reﬂection from

structures, objects and people.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Beurer IH 50 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van Beurer IH 50

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info