Handleiding Bestway 58340 Flowclear AquaScan Electric Pool Vacuum (pagina 2 van 68) (Alle talen)

686843

Verklein

Vergroot

Pagina terug

1/68

Pagina verder

NO. Description

Battery cover

Battery holder

Handle

On “I”/Off “O” button

Adjustable pole

Pole lock

Impeller

Water vent

Suction head

Brush

Note: Drawings for illustrations purpose only. May not

reflect the actual product. Not to scale.

Set Up of Vacuum Product

Brush Assembly

Align the curvature of brush with the suction head and

insert the brush into it securely (Fig.1).

Suction Head Assembly

Carefully discard the cardboard wrap around the impeller.

Don’t try to pull the wrap away directly, but cut and unroll it.

Any damage on impeller may cause it to function improperly.

Screw the suction head securely to the threaded connector as

shown (Fig.2).

Battery Assembly

Unscrew the battery cover and take out

the battery holder.

Place 8 AA batteries into the battery

holder according to the polarity marked

on it.

Align the rib and slide the battery holder

into the compartment with the word “TOP”

facing outwards as shown (Fig.3).

Screw the battery cover on tight and

make sure it is secure (avoid stripping the

screw).

CAUTION: Do not press the button to turn

the product on until the cleaner is

submerged in the water and water level is

above the water vent.

Fig.5

Fig.4Fig.4

Fig.6

Cleaning Your Pool or Spa

Place the product into water and make sure water level is above

the water vent. You can adjust the product length by unscrewing

the pole lock to release the top pole and then extend it to the

desired length according to your pool or spa size. Secure by

tightening the pole lock. Press the “I” marking on the button to start

vacuuming.

CAUTION: Never submerge the handle in

water. During operation, avoid water contact

with the handle and button. Never use the

product without filter basket in place. This can

cause permanent damage to the product

impeller and motor.

Cleaning the Pre-filter Bag

WARNING! Turn off the product before

proceeding following steps.

NOTE: Water will be stored inside the

transparent tube and the pole after use. To

remove the water, lift the product from the

pool or spa with the nozzle facing down to

allow the water to drain out.

1. Pull the edge (on back side) of cover to lift its tab (inside) from

the notch on the body, and then pull it down to completely

release the cover (Fig.4).

2. Pull out the pre-filter bag. Empty this bag by removing the

leaves and other debris, and then rinse it. Rinse the cover and

make sure its suction hole is not clogged (Fig.5).

3. Reverse the previous steps to assemble the pre-filter bag back

to the cover and then the cover to the body. Make sure the tabs

on cover inside (2 sides) are secured in the notch of the body

before next operation (Fig.6).

Maintenance and Storage

WARNING! Turn off the product before

any maintenance.

• Always check if the pre-filter bag is full

of debris. Clean if necessary.

• Always check if the suction nozzle is

clogged. Turn off the power

and clean it out.

•

If the impeller becomes clogged, be sure

the product is in the off position.

• Remove batteries from compartment.

Remove pre-filter bag and check for

holes or damage (replace if necessary).

• Flush water vent “8” with water.

Remove any visible debris. Replace

pre-filter bag, fittings, batteries and

battery cover. Place water vent under

water and turn product switch on. If still

cannot remove the debris by this way,

unscrew the impeller chamber and

remove the debris carefully, not to

damage the impeller.

NOTE:

Never pull and torque the impeller.

• After use, always drain water from the

unit by removing the nozzle, hold it

vertically, and dry it before storing.

• Do not leave the unit in the pool or spa

when not in use. Do not store under

direct sunlight.

• Do not store the unit outdoors or in a

location where the temperature falls

below freezing.

• Remove the batteries and the case

when the unit is not to be used for a

period.

• Always keep the battery chamber and

compartment dry.

Fig.3

Fig.2

Fig.1

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Bestway 58340 Flowclear AquaScan Electric Pool Vacuum Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info