779501
39
Verklein
Vergroot
Pagina terug
1/87
Pagina verder
76 77
MTB-PEDELEC | ORIGINAL OPERATING INSTRUCTIONS 2016 ORIGINAL OPERATING INSTRUCTIONS 2016 | MTB-PEDELEC
b ca e fd
ENGLISH
ENGLISH
To measure the travel you can use the rubber ring (b) mainly located on the
thinner, plunging tube of the rear shock. If there is no rubber ring, tie up a cable
tie around one of the thin tube. Make sure it is not too tight, you should still be
able to move it, it should however not slip by itself.
Put on your usual riding clothing (including if necessary a packed rucksack),
sit on your BERGAMONT bike and bring yourself into the usual riding position.
Lean against a fixed object (railings, wall etc.) and make sure you do not fall
over. Ask a helper to move the rubber ring or the cable tie downwards against
the dust seal at the lower leg.
Get off your BERGAMONT bike so that the rear frame does not compress any
more. The distance between the rubber ring/cable tie and the wiper is the
negative suspension travel, or sag (c). Compare it with the total spring travel
(manufacturer specifications) of the rear shock, not rear frame, or measure as
a reference point the straight and smooth area which compresses (c) to deter-
mine whether the suspension needs harder or softer setting.
In the case of air spring rear shocks the spring rate is set by means of the air
pressure in the rear shock (d). The pressure must be set before the first ride by
means of a special high-pressure pump with pressure gauge and modified later
as required due to changes in the weight of the rider and/or load.
Note the appropriate setting values and check them subsequently at regular
intervals. Always follow the recommendations of the manufacturer and never
exceed the maximum air pressure for the rear shock. Always make a test ride
after each change to the settings.
In the case of most rear shocks with coil springs a preload can be applied to
the springs within tight limits by turning a knob (e). If that is not possible and
the desired negative suspension travel (“sag”) cannot be set, the coil spring
must be replaced by a harder or softer model. The replacement is a job for your
BERGAMONT dealer.
When replacing any parts, be sure to only use parts that bear the appropriate
mark and, to be on the safe side, original spare parts. Your BERGAMONT dealer
will be pleased to help you.
Make sure the valve is always protected with the valve cap (f) during use.
What to bear in mind when adjusting the seating position
According to the rear shock adjustment the saddle can tilt a little backwards.
Keep this in mind when adjusting the saddle tilt. If you have trouble sitting, try
lowering the nose of the saddle a little compared to your usual position.
For dirt, freeride and downhill use the saddle is often set to a very low position
and tilted backwards.
NOTE!
I
Full suspension BERGAMONT bikes have a greater ground clearance than
bicycles without rear suspension. If the saddle is adjusted to its proper
height you will normally not be able to reach the floor with your feet. Set the
saddle a little lower to begin with and practise getting on and off the saddle.
Adjusting the spring rate
To work perfectly, the rear shock has to be adjusted to the weight of the rider,
the sitting posture and the intended use. Be sure to have this adjustment carried
out by your BERGAMONT dealer at the time of delivery.
Note in general that the rear frame must give in a little even when you are just
sitting on your BERGAMONT bike – this is negative suspension travel, also
referred to as sag (a). If you ride over a pothole the spring is decompressed and
the rear frame compensates for the unevenness. If the air pressure or the spring
preload is too high, this effect is lost because the rear frame is already fully
extended. This means that an important comfort and safety factor is lost if the
tyre briefly loses contact with the ground.
In general, cross-country and marathon racers prefer a shorter negative sus-
pension travel (sag), whereas freeriders or downhillers riding often in rough
terrain prefer a longer one. In the case of BERGAMONT cross-country and
BERGAMONT marathon bikes the rear frame should yield by 10-20 % of
the maximum suspension travel, in the case of BERGAMONT all mountain,
BERGAMONT enduro and BERGAMONT freeride bikes by 25-35 %.
39

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Bergamont Pedelec 2016 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Bergamont Pedelec 2016 in de taal/talen: Engels als bijlage per email.

De handleiding is 21.14 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info